Owner's Manual

CONNECTING AND OPERATING

THE COMPONENT WITH AUDIO EXTENDER

Connect the Component output from your source to the input on 1.

the Component with Audio Extender sender unit with the supplied

Component cables.

Connect the audio output (analog or digital) from your source to the 2.

input on the Component with Audio Extender sender unit with either the

supplied analog audio cables or with user supplied digital cables.

Connect the Component input of your display to the Component output 3.

on the Component with Audio Extender receiver unit with user supplied

Component cables.

Connect the audio input of your display to the audio output on the 4.

Component with Audio Extender receiver unit with user supplied analog

or digital cables.

Connect a CAT-5, CAT-5e, or CAT-6 cable between the Component 5.

with Audio Extender sender unit and the Component with Audio

Extender receiver unit.

Plug the supplied 5V DC power supply the Component with Audio 6.

Extender sending and receiving units.

Poweronthedisplayrst,andthenthesource.7.

Wire your CAT-5, CAT-5e, or CAT-6 as a “straight through” cable, using the 8.

TIA/EIA-568-B wiring standard. Do not mix different types of cable. Please see

page 7 for a network cable wiring diagram.

Note:Adjustmentstobrightnessandfocusmaybenecessarytonetune

the signal. Please see below for the proper procedures.

How to Connect the Component With Audio Extender

BRIGHTNESS AND FOCUS TRIM POTS

The brightness and focus adjustments are found on the receiver unit and will help

compensate for issues that can be introduced by outside interference and cable

variances. If the outgoing image is too dark or too bright, the brightness trim pot can

be tuned to help brighten the image. If there is a ghosting or blurring effect on the

image,thefocustrimpotcanbeusedtoeliminatetheseartifacts.Insertasmallat

head device, such as a screw driver into either the brightness or focus trim pot hole.

Turn the trim pot in millimeter increments in either a clockwise or counterclockwise

direction. Once the desired brightness and focus are reached, simply remove the

adjustment device from the trim pot hole.

Power LED

Indicator