Owner's Manual

Extend your audio and video signal using the Linear Component with Audio Extender.
Place your source anywhere and extend the signal up to a 1000 feet away. The
Component with Audio Extender will extend Analog Component as well as Analog
Audio or Digital Audio (SPDIF or Optical). All audio and video signals are transmitted
digitally over a single CAT-5, CAT-5e, or CAT-6 cable and both the analog and digital
audio outputs are active on the receiver side.
How It Works
The Component with Audio Extender sender unit connects to any component video
and audio source using the supplied Component and RCA cables. The receiver unit
connects to your HDTV component video display and audio input up to 1000 feet away.
Only one CAT-5, CAT-5e, or CAT-6 cable is used to connect the sender to receiver
for perfect video extension up to 1080p. The sender and receiver are powered by
individual 5V DC power supplies.
INTRODUCTION
1
READ THESE NOTES BEFORE INSTALLING OR
OPERATING THE COMPONENT WITH AUDIO EXTENDER SYSTEM
Use industry standard CAT-5, CAT-5e, or CAT-6 cable to operate the Component •
with Audio Extender system. Solid core CAT-6 cable is recommended for best
results.
Please connect all the cables between the source, display, and the Component •
with Audio Extenders before powering the units.
The Component with Audio Extender units are housed in a metal box for better •
RF shielding.
Each cable run must be one continuous run from one end to the other. No •
splices or use of punch down blocks.
The •
Component with Audio Extender has the ability to convert analog audio
signals to digital, and digital audio signals to analog. It will cross-convert any
2 channel audio signal (analog or digital) or pass multi-channel audio directly
from the digital inputs to the digital outputs. However, it cannot down-mix digital
multichannel audio to the 2 channel analog outputs. Do not attempt to connect
the 2 channel analog audio outputs when passing digital multi-channel content.
The resulting output will be unrecognizable. Additionally, the
Component with
Audio Extender
can cross-convert between digital SPDIF and digital Optical
formats. For example, you can input a digital SPDIF cable on the sender and
connect an digital optical cable on the output.
OPERATION NOTES