Owner's Manual

BioRead 1000 Series

Installation Manual

Notes:

1. The relay activation time is fixed at 7 seconds.

2. If a door contact is used, it is connected to the DC pin of the BioRead Door

Controller.

3. The Door Contact will ensure that the Relay Activation Time is stopped.

4. The BioRead Door Controller turns the RIGHT LED of the BioRead reader

GREEN to indicate relay activation. The LEFT LED on the BioRead turns

GREEN after a valid fingerprint authentication.

5. Relay can switch up to 2A@24VDC. Do not switch high current/voltage

through this relay.

ee Operator Instructions for programming BioRead with the Hand-Held Programmer.

p/n 6035000 rev 2.0 Page 9 of 22