Manualshelf

Owner's Manual

ManualsBrandsLinear ManualsMisc ElectronicsLinear BioRead 1000/1100
11121314151617181920
BioRead 1000 Series
Installation Manual
Setting the Site Code on the SSIM board
ode with the BioRead, remember to properly set the SSIM
. Set dipswitches 1-8 to reflect the Site Code that you defined into the handheld
. Set dipswitch 9 to ON. This will enable the Site Code feature of the SSIM. If this switch
ween the BioRead and the SSIM.
a Site Code Chart,
If you wish to employ a site c
board by:
1
programmer of the BioRead.
2
is OFF there will be no Site Code verification bet
The SSIM board is sold with an installation manual that also has
which translates a decimal number (like 11) into a binary number that can be set using
the dipswitches on the SSIM board.
NOTE: THE SITE CODE (aka FACILITY CODE) THAT THE IEI BIOREAD USES IS
TO THE
THE LAST 3 DIGITS OF THE PASSWORD PROGRAMMED IN
HAND-HELD PROGRAMMER
p/n 6035000 rev 2.0 Page 16 of 22
SEE THE BIOREAD SETUP AND OPERATOR GUIDE (6035001) FOR
INFORMATION ON SETTING UP THE HAND HELD PROGRAMMER