Owner's Manual

4 of 17

POWER UNIT INSTALLATION

ILLUSTRATION ABOVE SHOWS A TYPICAL AIR VAC UNIT

Model Exhaust

Side

ABCDFG

AV2500 R 14 16 2.8 4 8 23 24 38 18

AV3500 R 14 16 2.8 4 8 23 24 38 18

AV4500 R 14 16 2.8 4 8 23 24 38 18

AV5500 R 14 16 2.8 4 8 23 24 38 18

FX2000 L 14 16 8.9 4 7 4 28 30 18

FX3000 L 14 16 8.9 4 7 4 28 30 18

FX900 L 14168.947 4 283018

ZX5800 L 14 16 8.9 4 7 4 28 31 18

ZX6000 L 14 16 8.9 4 7 4 28 31 18

ZX7000 L 14 16 8.9 4 7 4 28 31 18

ZX8000 L 14 16 8.9 4 7 4 28 31 18

Note: Dimensions above are in inches

5 of 17

Figure 1

POWER UNIT INSTALLATION

1.0 POWER UNIT LOCATION AND CONNECTION

The Vacuum System Power Unit is normally placed in the garage

(best location), utility room, or basement. Attic locations should be

avoided (A) if canister is difficult for the user to service, (B) where

temperature exceeds 140 degrees. The Power Unit should be located

out of traffic while still accessible for emptying of dirt canister.

2.0 POWER UNIT MOUNTING

For the AV series vacuum the top of the power unit must be a

minimum of 18" from the ceiling and 18" from the corner walls. For the

FX/ZX series the bottom of the power unit must be a minimum of 18"

from the floor and 18" from the corner walls. This clearance is

necessary to allow adequate air flow to cool motors. If exhaust is

used, refer to Figure 1.