Black 0001 Digital Keyless Entry System Installation and Programming Instructions (760) 438-7000 • FAX (760) 438-7043 USA & Canada (800) 421-1587 & (800) 392-0123 Toll Free FAX (800) 468-1340 www.linearcorp.
Black 0002 CONTENTS INTRODUCTION . . . . . . . . SPECIFICATIONS . . . . . . . FEATURES . . . . . . . . . . . COMPONENT LOCATIONS . . . WIRING DIAGRAM . . . . . . INSTALLATION . . . . . . . . FACTORY DEFAULTS . . . . . . BASIC PROGRAMMING . . . . PROGRAMMING OPTIONS . . ACCESSKEY OPERATION . . . . MANAGER’S ENTRY CODE LOG LINEAR LIMITED WARRANTY . FCC NOTICE . . . . . . . . . . SPECIFICATIONS . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Black 0003 COMPONENT LOCATIONS RED/GREEN POWER/ACCESS INDICATOR YELLOW "LOCKOUT" INDICATOR JUMPER JP2 RESETS MASTER CODE TERMINAL BLOCK J3 OUTPUTS NIGHT LIGHT TACTILE KEYPAD TERMINAL BLOCK J4 POWER AND INPUTS JUMPER JP1 REMOVE TO REDUCE BEEPER SOUND KEYLOCK Figure 1. Component Locations WIRING DIAGRAM TYPICAL GATE INSTALLATION WIRING TYPICAL DOOR INSTALLATION WIRING ACCESSKEY ACCESSKEY J3 J3 N.O. 1 RELAY #1 N.O. 1 COMMON 2 RELAY #1 N.C. 3 J4 N.C.
Black 0004 INSTALLATION To avoid damage to the unit from static discharges, connect the EARTH GROUND terminal to a good earth grounding point. Suggested wiring size is 18 AWG for earth ground and power (up to 500 feet of 18 AWG wire can be run for power, use larger wire for longer runs). Use 22 AWG or larger (depending on the load) for all other connections.
Black Gate Control Route four wires between the gate and the keypad (two for power, two for control). Connect the gate operator’s auxiliary or radio power output terminals to the keypads POWER input terminals (observe wiring polarity). Connect the gate operator’s OPEN terminals to the keypad’s Relay #1 COMMON & N.O. terminals. NOTE: For operator wiring specifics, refer to the gate operator’s wiring diagram.
Black FACTORY DEFAULTS 0006 Setting Entry Code Length MASTER PROGRAMMING CODE. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 123456 ENTRY CODE LENGTH. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 DIGITS REQUEST-TO-ENTER OUTPUT . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . RELAY #1 ALARM SHUNT OUTPUT. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . DISABLED FORCED ENTRY OUTPUT . . . . . . . . . . . . . . . . . . . . . .
Black 0007 PROGRAMMING OPTIONS There are several AccessKey programming options. For most installations, the factory set default options are sufficient. The keypad must be in programming mode to make these changes. Programming Accesskey to Hold the Output Linear’s AccessKey products have a programmable “Toggle Mode” available for each relay and solid-state output. When an output is programmed for Toggle Mode, the output alternates from OFF to ON or from ON to OFF each time it is activated.
Black 0008 Select Request-to-Enter Output Default: Relay #1 Sets which output activates when the Request-to-Enter input is grounded. This output may be timed or toggled. Beep Sounds During Output #3 Default: No Selects whether or not the keypad beeps during Output #3 activation.
Black 0009 Solid State Outputs The two solid state outputs (Output #3 & Output #4) can be programmed to activate during various conditions. These outputs can be used to activate indicators or sounders. See Figure 7 for wiring examples using the solid state outputs. Locking Keypad After the installation is complete. Lock the keypad using the keylock (see Figure 9).
Black ACCESSKEY OPERATION Users of the AccessKey have up to 40 seconds to key in their entry code. Up to eight seconds are allowed between each keystroke. All digits of the entry code must be entered. Example: If the code is 0042, the user must enter “0 0 4 2”. If the wrong key is pressed, pressing the key will reset the keypad. The correct code can then be re-entered. After a correct code is entered, the red LED will turn green and the programmed relay will activate for the programmed time.
Black 0011 MANAGER’S ENTRY CODE LOG NAME ADDRESS OR APARTMENT NUMBER ENTRY CODE RELAY NUMBER ◊1 ◊1 ◊1 ◊1 ◊1 ◊1 ◊1 ◊1 ◊1 ◊1 ◊1 ◊1 ◊1 ◊1 ◊1 ◊1 ◊1 ◊1 ◊1 ◊1 ◊1 ◊1 ◊1 ◊1 ◊1 ◊1 ◊1 ◊1 ◊1 ◊1 ◊1 ◊1 ◊1 ◊1 ◊1 ◊2 ◊2 ◊2 ◊2 ◊2 ◊2 ◊2 ◊2 ◊2 ◊2 ◊2 ◊2 ◊2 ◊2 ◊2 ◊2 ◊2 ◊2 ◊2 ◊2 ◊2 ◊2 ◊2 ◊2 ◊2 ◊2 ◊2 ◊2 ◊2 ◊2 ◊2 ◊2 ◊2 ◊2 ◊2 11 0011 Black
Black 0012 LINEAR LIMITED WARRANTY FCC NOTICE This Linear product is warranted against defects in material and workmanship for twelve (12) months. The Warranty Expiration Date is labeled on the product. This warranty extends only to wholesale customers who buy direct from Linear or through Linear’s normal distribution channels. Linear does not warrant this product to consumers. Consumers should inquire from their selling dealer as to the nature of the dealer’s warranty, if any.
