Quick Start Manual

INSTALLATIONINSTRUCTION
7. Mount plastic
bumpers on both
s i d e s o f t h e
safety edge. Use
included sheet
metal screws for
installation to the
door section.
8. Wire the short end of the coil cord
through the bend protection into
the junction box. Connect it to the
sensor cable.
9. Use included steel mounting bra-
cket to install the long end of the
coil cord at the halfway point of the
door height.
10. Connect coil cord to the dynamic 2-
wire interface of the operator. Do
NOT connect to the Normally Open
Contact.
WiringDiagram
FRABA Inc.
1800EStateStreet,Suite148,HamiltonNJ08609
Phone1-609-750-8705,Fax1-609-750-8703
www.vitector.com,info@vitector.com
IssueDate:27-Aug-2010