Quick Start Manual

Remote Power Using the model 2010
Sending IR Signals on the Coax
Attention:
Incorrect connections can damage the amplifier or 2010.
3
Power
Supply
2010
Power Injector
modulator
DVD
Up to
8 TVs
CATV or
Ant
Note:
The model 2010
must be connected
to the (pwr) port.
With remote power, the coax panel can
be placed closest to the output coax lines:
in the attic, basement or the garage.
If you need to add IR but cannot change to a full coaxial cable panel, use
this illustration to build an RF passive IR repeating system. Just add targets
and emitters and you’re done.
Power
Supply
model 2100A
IR interface
Connect emitters to the 2010 or
any 2100A in the system.
Connect targets to any
2100A in the system.
Use IR passing
splitters only!
model 2512 or
2514 splitter
Use a DC-Block
when NOT using a
2100A IR interface.
The 2010 has
a built-in circuit
breaker. If the
LEDs on the 2100As are not
glowing, unplug the power
supply, then plug it back in
to reset the breaker.
2010
Power Injector
2
Correct connections:
model 2100A
IR interface
Wrong
connections:
You may connect a 2100A or a
DC-block directly to an
amplifier.
TVs without a 2100A or
a splitter without IR must
have a DC-block
between the it and
the amplifier.
DC-blocks
Connecting a splitter
or a 75ohm termina-
tor DIRECTLY to an
amplifier will cause
the circuit breaker
to trip.
PRINTER’S INSTRUCTIONS:
INSTR,INSTL,2010 - LINEAR P/N: 600-084 C - INK: BLACK - MATERIAL: 20# MEAD BOND - SIZE: 8.500” x 11.000” - FOLDING: 1 FOLD VERTICAL - SCALE: 1-1 - SIDE 2 OF 2