Datasheet

LTC3890
21
3890fc
APPLICATIONS INFORMATION
INTV
CC
Regulators
The LTC3890 features two separate internal P-channel low
dropout linear regulators (LDO) that supply power at the
INTV
CC
pin from either the V
IN
supply pin or the EXTV
CC
pin depending on the connection of the EXTV
CC
pin.
INTV
CC
powers the gate drivers and much of the LTC3890’s
internal circuitry. The V
IN
LDO and the EXTV
CC
LDO regulate
INTV
CC
to 5.1V. Each of these can supply a peak current of
50mA and must be bypassed to ground with a minimum
of 4.7µF ceramic capacitor. No matter what type of bulk
capacitor is used, an additional 1µF ceramic capacitor
placed directly adjacent to the INTV
CC
and PGND pins is
highly recommended. Good bypassing is needed to supply
the high transient currents required by the MOSFET gate
drivers and to prevent interaction between the channels.
High input voltage applications in which large MOSFETs
are being driven at high frequencies may cause the maxi-
mum junction temperature rating for the LTC3890 to be
exceeded. The INTV
CC
current, which is dominated by
the gate charge current, may be supplied by either the
V
IN
LDO or the EXTV
CC
LDO. When the voltage on the
EXTV
CC
pin is less than 4.7V, the V
IN
LDO is enabled. Power
dissipation for the IC in this case is highest and is equal
to V
IN
• I
INTVCC
. The gate charge current is dependent on
operating frequency as discussed in the Efficiency Consid-
erations section. The junction temperature can be estimated
by using the equations given in Note 3 of the Electrical
Characteristics. For example, the LTC3890 INTV
CC
current
is limited to less than 32mA from a 40V supply when not
using the EXTV
CC
supply at a 70°C ambient temperature:
T
J
= 70°C + (32mA)(40V)(43°C/W) = 125°C
To prevent the maximum junction temperature from be-
ing exceeded, the input supply current must be checked
while operating in forced continuous mode (PLLIN/MODE
= INTV
CC
) at maximum V
IN
.
When the voltage applied to EXTV
CC
rises above 4.7V, the
V
IN
LDO is turned off and the EXTV
CC
LDO is enabled. The
EXTV
CC
LDO remains on as long as the voltage applied to
EXTV
CC
remains above 4.5V. The EXTV
CC
LDO attempts
to regulate the INTV
CC
voltage to 5.1V, so while EXTV
CC
is less than 5.1V, the LDO is in dropout and the INTV
CC
voltage is approximately equal to EXTV
CC
. When EXTV
CC
is greater than 5.1V, up to an absolute maximum of 14V,
INTV
CC
is regulated to 5.1V.
Using the EXTV
CC
LDO allows the MOSFET driver and
control power to be derived from one of the LTC3890’s
switching regulator outputs (4.7V ≤ V
OUT
≤ 14V) during
normal operation and from the V
IN
LDO when the output
is out of regulation (e.g., start-up, short-circuit). If more
current is required through the EXTV
CC
LDO than is speci-
fied, an external Schottky diode can be added between the
EXTV
CC
and INTV
CC
pins. In this case, do not apply more
than 6V to the EXTV
CC
pin and make sure that EXTV
CC
≤ V
IN
.
Significant efficiency and thermal gains can be realized
by powering INTV
CC
from the output, since the V
IN
cur-
rent resulting from the driver and control currents will be
scaled by a factor of (Duty Cycle)/(Switcher Efficiency).
For 5V to 14V regulator outputs, this means connecting
the EXTV
CC
pin directly to V
OUT
. Tying the EXTV
CC
pin to
an 8.5V supply reduces the junction temperature in the
previous example from 125°C to:
T
J
= 70°C + (32mA)(8.5V)(43°C/W) = 82°C
However, for 3.3V and other low voltage outputs, additional
circuitry is required to derive INTV
CC
power from the output.
Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.