Datasheet

LTC3883/LTC3883-1
66
3883fa
For more information www.linear.com/LTC3883
MFR_CONFIG_ALL_LTC3883
General purpose configuration command common to multiple LT C products
BIT MEANING
7 Enable Fault Logging
6 Ignore Resistor Configuration Pins
5 Reserved
4 Reserved
3 Mask PLL Unlock Fault
2 A valid PEC required for PMBus writes to be accepted. If this bit is not
set, the part will accept commands with invalid PEC.
1 Enable the use of PMBus clock stretching
0 Reserved
This command has one data byte.
ON/OFF/MARGIN
COMMAND NAME
CMD
CODE DESCRIPTION TYPE
DATA
FORMAT UNITS NVM
DEFAULT
VALUE
ON_OFF_CONFIG 0x02 RUN pin and PMBus bus on/off command configuration. R/W Byte Reg Y 0x1E
OPERATION 0x01 Operating mode control. On/off, margin high and margin low. R/W Byte Reg Y 0x80
MFR_RESET 0xFD Commanded reset without requiring a power-down. Send Byte NA
ON_OFF_CONFIG
The ON_OFF_CONFIG command configures the combination of RUN pin input and serial bus commands needed to
turn the unit on and off. This includes how the unit responds when power is applied.
The only bits allowed to be changed are as follows:
3: Controls how the unit responds to commands received via the serial bus
0: RUN pin action when commanding the unit to turn off. If bit 0 is set to one, the part will stop transferring power to
the output stage as fast as possible. This will have the effect of the load discharging the output capacitor. Setting
bit 0 to a zero will cause the regulator to use the programmed turn-off delay and fall times. If the part is in continu
-
ous mode, the programmed turn-off response may pull the output to zero volts considerably faster than removing
power
immediately from the load.
Changing the value of bits 4, 2 or 1, will generate a CML fault.
This command has one data byte.
PMBus COMMAND DETAILS