Datasheet

LTC3859AL
31
3859alf
For more information www.linear.com/3859AL
applicaTions inForMaTion
VCO input. If the external and internal frequencies are the
same but exhibit a phase difference, the current sources
turn on for an amount of time corresponding to the phase
difference. The voltage at the VCO input is adjusted until
the phase and frequency of the internal and external os-
cillators are identical. At the stable operating point, the
phase detector output is high impedance and the internal
filter capacitor, CLP, holds the voltage at the VCO input.
Note that the LTC3859AL can only be synchronized to
an external clock whose frequency is within range of the
LTC3859AL’s internal VCO, which is nominally 55kHz to
1MHz. This is guaranteed to be between 75kHz and 850kHz.
Typically, the external clock (on PLLIN/MODE pin) input
high threshold is 1.6V, while the input low threshold is 1.2V.
Rapid phase-locking can be achieved by using the FREQ
pin to set a free-running frequency near the desired
synchronization frequency. The VCO’s input voltage is
prebiased at a frequency correspond to the frequency
set by the FREQ pin. Once prebiased, the PLL only needs
to adjust the frequency slightly to achieve phase-lock
and synchronization. Although
it is not required that the
free-running
frequency be near external clock frequency,
doing so will prevent the operating frequency from pass-
ing through a large range of frequencies as the PLL locks.
Table 1 summarizes the different states in which the FREQ
pin can be used.
Table 1
FREQ PIN PLLIN/MODE PIN FREQUENCY
0V DC Voltage 350kHz
INTV
CC
DC Voltage 535kHz
Resistor to SGND DC Voltage 50kHz to 900kHz
Any of the Above External Clock Phase-Locked to
External Clock
Minimum On-Time Considerations
Minimum on-time t
ON(MIN)
is the smallest time duration that
the LTC3859AL is capable of turning on the top MOSFET
(bottom MOSFET for the boost controller). It is determined
by internal timing delays and the gate charge required to
turn on the top MOSFET. Low duty cycle applications may
approach this minimum on-time limit and care should be
taken to ensure that
t
ON(MIN)_BUCK
<
V
OUT
V
IN
(f)
t
ON(MIN)_BOOST
<
V
OUT
− V
IN
V
OUT
(f)
If the duty cycle falls below what can be accommodated
by the minimum on-time, the controller will begin to skip
cycles. The output voltage will continue to be regulated,
but the ripple voltage and current will increase.
The minimum on-time for the LTC3859AL is approximately
95ns for the bucks and 120ns for the boost. However, as
the peak sense voltage decreases the minimum on-time
gradually increases up to about 130ns. This is of particu-
lar concern in forced continuous applications with low
ripple current at light loads. If the duty cycle drops below
the minimum on-time limit in this situation, a significant
amount of cycle skipping can occur with correspondingly
larger current and voltage ripple.