Datasheet

LTC3827
16
3827ff
R
SENSE
Selection for Output Current
R
SENSE
is chosen based on the required output current.
The current comparator has a maximum threshold of
100mV/R
SENSE
and an input common mode range of
SGND to 10V. The current comparator threshold sets the
peak of the inductor current, yielding a maximum average
output current I
MAX
equal to the peak value less half the
peak-to-peak ripple current, ΔI
L
.
Allowing a margin for variations in the IC and external
component values yields:
R
SENSE
=
80mV
I
MAX
When using the controller in very low dropout conditions,
the maximum output current level will be reduced due to the
internal compensation required to meet stability criterion for
buck regulators operating at greater than 50% duty factor. A
curve is provided in the Typical Performance Characteristics
section to estimate this reduction in peak output current
level depending upon the operating duty factor.
Operating Frequency and Synchronization
The choice of operating frequency, is a trade-off between
effi ciency and component size. Low frequency operation
improves effi ciency by reducing MOSFET switching losses,
both gate charge loss and transition loss. However, lower
frequency operation requires more inductance for a given
amount of ripple current.
The internal oscillator for each of the LTC3827’s controllers
runs at a nominal 400kHz frequency when the PLLLPF pin
is left fl oating and the PLLIN/MODE pin is a DC low or high.
Pulling the PLLLPF to INTV
CC
selects 530kHz operation;
pulling the PLLLPF to SGND selects 250kHz operation.
Alternatively, the LTC3827 will phase-lock to a clock
signal applied to the PLLIN/MODE pin with a frequency
between 140kHz and 650kHz (see Phase-Locked Loop
and Frequency Synchronization).
APPLICATIONS INFORMATION
Inductor Value Calculation
The operating frequency and inductor selection are inter-
related in that higher operating frequencies allow the use
of smaller inductor and capacitor values. So why would
anyone ever choose to operate at lower frequencies with
larger components? The answer is effi ciency. A higher
frequency generally results in lower effi ciency because
of MOSFET gate charge losses. In addition to this basic
trade-off, the effect of inductor value on ripple current and
low current operation must also be considered.
The inductor value has a direct effect on ripple current.
The inductor ripple current ΔI
L
decreases with higher
inductance or frequency and increases with higher V
IN
:
I
L
=
1
(f)(L)
V
OUT
1–
V
OUT
V
IN






Accepting larger values of ΔI
L
allows the use of low
inductances, but results in higher output voltage ripple
and greater core losses. A reasonable starting point for
setting ripple current is ΔI
L
= 0.3(I
MAX
). The maximum
ΔI
L
occurs at the maximum input voltage.
The inductor value also has secondary effects. The tran-
sition to Burst Mode operation begins when the average
inductor current required results in a peak current below
10% of the current limit determined by R
SENSE
. Lower
inductor values (higher ΔI
L
) will cause this to occur at
lower load currents, which can cause a dip in effi ciency in
the upper range of low current operation. In Burst Mode
operation, lower inductance values will cause the burst
frequency to decrease.
Inductor Core Selection
Once the value for L is known, the type of inductor must
be selected. High effi ciency converters generally cannot
afford the core loss found in low cost powdered iron cores,
forcing the use of more expensive ferrite or molypermalloy
cores. Actual core loss is independent of core size for a
fi xed inductor value, but it is very dependent on inductance