Datasheet

LTC3827-1
24
38271fe
APPLICATIONS INFORMATION
PC Board Layout Checklist
When laying out the printed circuit board, the following
checklist should be used to ensure proper operation of
the IC. These items are also illustrated graphically in the
layout diagram of Figure 11. Figure 12 illustrates the current
waveforms present in the various branches of the 2-phase
synchronous regulators operating in the continuous mode.
Check the following in your layout:
1. Are the top N-channel MOSFETs M1 and M3 located
within 1cm of each other with a common drain connec-
tion at C
IN
? Do not attempt to split the input decoupling
for the two channels as it can cause a large resonant
loop.
2. Are the signal and power grounds kept separate? The
combined IC signal ground pin and the ground return
of C
INTVCC
must return to the combined C
OUT
(–) termi-
nals. The path formed by the top N-channel MOSFET,
Schottky diode and the C
IN
capacitor should have short
leads and PC trace lengths. The output capacitor (–)
terminals should be connected as close as possible
to the (–) terminals of the input capacitor by placing
the capacitors next to each other and away from the
Schottky loop described above.
3. Do the LTC3827 V
FB
pins’ resistive dividers connect to
the (+) terminals of C
OUT
? The resistive divider must be
connected between the (+) terminal of C
OUT
and signal
ground. The feedback resistor connections should not
be along the high current input feeds from the input
capacitor(s).
Figure 11. LTC3827-1 Recommended Printed Circuit Layout Diagram
C
B2
C
B1
R
PU
PGOOD1
V
PULL-UP
(<8.5V)
C
INTVCC
+
C
IN
D1
1µF
CERAMIC
M1 M2
M3
M4
D2
+
C
VIN
V
IN
R
IN
I
TH1
V
FB1
SENSE1
+
SENSE1
–
PLLLPF
PLLIN/MODE
SGND
RUN1
RUN2
SENSE2
–
SENSE2
+
V
FB2
I
TH2
TRACK/SS2
TRACK/SS1
PGOOD1
TG1
SW1
BOOST1
BG1
V
IN
PGND
EXTV
CC
INTV
CC
BG2
BOOST2
SW2
TG2
LTC3827-1
L1
L2
C
OUT1
V
OUT1
GND
V
OUT2
38271 F11
+
C
OUT2
+
R
SENSE
R
SENSE
f
IN
1µF
CERAMIC