Datasheet

LTC3783
17
3783fb
OPERATION
From a known power dissipated in the power MOSFET, its
junction temperature can be obtained using the following
formula:
T
J
= T
A
+ P
FET
• θ
JA
The θ
JA
to be used in this equation normally includes the
θ
JC
for the device plus the thermal resistance from the
case to the ambient temperature (
θ
CA
). This value of T
J
can then be compared to the original, assumed value used
in the iterative calculation process.
Boost Converter: Output Diode Selection
To maximize efficiency, a fast switching diode with low
forward drop and low reverse leakage is desired. The output
diode in a boost converter conducts current during the
switch off-time. The peak reverse voltage that the diode
must withstand is equal to the regulator output voltage.
The average forward current in normal operation is equal
to the output current, and the peak current is equal to the
peak inductor current.
I
D(PEAK)
= I
L(PEAK)
= 1+
c
2






•
I
OUT(MAX)
1– D
MAX
The power dissipated by the diode is:
P
D
= I
OUT(MAX)
• V
D
and the diode junction temperature is:
T
J
= T
A
+ P
D
• θ
JA
The θ
JA
to be used in this equation normally includes the
θ
JC
for the device plus the thermal resistance from the
board to the ambient temperature in the enclosure.
Remember to keep the diode lead lengths short and to
observe proper switch-node layout (see Board Layout
Checklist) to avoid excessive ringing and increased
dissipation.
Boost Converter: Output Capacitor Selection
Contributions of ESR (equivalent series resistance), ESL
(equivalent series inductance) and the bulk capacitance
must be considered when choosing the correct component
for a given output ripple voltage. The effects of these three
parameters (ESR, ESL and bulk C) on the output voltage
ripple waveform are illustrated in Figure 9 for a typical
boost converter.
V
OUT
(AC)
∆V
ESR
RINGING DUE TO
TOTAL INDUCTANCE
(BOARD + CAP)
∆V
COUT
3783 F09
Figure 9. Output Ripple Voltage
The choice of component(s) begins with the maximum
acceptable ripple voltage (expressed as a percentage of
the output voltage), and how this ripple should be divided
between the ESR step and the charging/discharging ∆V.
For the purpose of simplicity we will choose 2% for the
maximum output ripple, to be divided equally between the
ESR step and the charging/discharging ∆V. This percentage
ripple will change, depending on the requirements of the
application, and the equations provided below can easily
be modified.
For a 1% contribution to the total ripple voltage, the ESR
of the output capacitor can be determined using the fol-
lowing equation:
ESR
COUT
< 0.01•
V
OUT
I
IN(PEAK)
where :
I
IN(PEAK)
= 1+
c
2






•
I
OUT(MAX)
1– D
MAX
For the bulk C component, which also contributes 1% to
the total ripple:
C
OUT
>
I
OUT(MAX)
0.01• V
OUT
• f