Datasheet

LTC2497
24
2497fa
INPUT FREQUENCY (Hz)
0
20 40 60 80 100 120 140 160 180 200 220
NORMAL MODE REJECTION (dB)
2497 F18
0
–20
–40
–60
–80
–100
–120
V
CC
= 5V
V
REF
= 5V
V
IN(CM)
= 2.5V
V
IN(P-P)
= 5V
T
A
= 25°C
MEASURED DATA
CALCULATED DATA
INPUT FREQUENCY (Hz)
0
15 30 45 60 75 90 105 120 135 150 165 180 195 210 225 240
NORMAL MODE REJECTION (dB)
2497 F19
0
–20
–40
–60
–80
–100
–120
V
CC
= 5V
V
REF
= 5V
V
IN(CM)
= 2.5V
T
A
= 25°C
V
IN(P-P)
= 5V
V
IN(P-P)
= 7.5V
(150% OF FULL SCALE)
by the user and can be made insignificantly short. When
operating with an external conversion clock (f
O
connected
to an external oscillator), the LTC2497 output data rate
can be increased. The duration of the conversion cycle is
41036/f
EOSC
. If f
EOSC
= 307.2kHz, the converter behaves
as if the internal oscillator is used.
An increase in f
EOSC
over the nominal 307.2kHz will trans-
late into a proportional increase in the maximum output
data rate (up to a maximum of 100sps). The increase in
output rate leads to degradation in offset, full-scale error,
and effective resolution as well as a shift in frequency
rejection.
A change in f
EOSC
results in a proportional change in the
internal notch position. This leads to reduced differential
mode rejection of line frequencies. The common mode
rejection of line frequencies remains unchanged, thus fully
differential input signals with a high degree of symmetry
on both the IN
+
and IN
–
pins will continue to reject line
frequency noise.
An increase in f
EOSC
also increases the effective dynamic
input and reference current. External RC networks will
continue to have zero differential input current, but the
time required for complete settling (580ns for f
EOSC
=
307.2kHz) is reduced, proportionally.
Once the external oscillator frequency is increased above
1MHz (a more than 3X increase in output rate) the effective-
ness of internal auto calibration circuits begins to degrade.
This results in larger offset errors, full-scale errors, and
decreased resolution, as shown in Figures 20 to 27.
Figure 18. Input Normal Mode Rejection vs Input Frequency with
Input Perturbation of 100% (50Hz/60Hz Notch)
Figure 19. Measure Input Normal Mode Rejection vs Input
Frequency with Input Perturbation of 150% (60Hz Notch)
applicaTions inForMaTion