Datasheet
LTC2444/LTC2445/
LTC2448/LTC2449
22
2444589fc
For more information www.linear.com/LTC2444
applicaTions inForMaTion
Internal Serial Clock, 2-Wire I/O, Continuous
Conversion
This timing mode uses a 2-wire, all output (SCK and SDO)
interface. The conversion result is shifted out of the device
by an internally generated serial clock (SCK) signal, see
Figure 10. CS may be permanently tied to ground, sim
-
plifying the user interface or isolation barrier. The internal
serial clock mode is selected by tying EXT HIGH.
During the conversion, the SCK and the serial data output
pin (SDO) are HIGH (EOC = 1) and BUSY = 1. Once the
conversion is complete, SCK, BUSY and SDO go LOW (EOC
= 0) indicating the conversion has finished and the device
has entered the low power sleep state. The part remains in
the sleep state a minimum amount of time (≈500ns) then
immediately begins outputting data. The data output cycle
begins on the first rising edge of SCK and ends after the
32nd rising edge. Data is shifted out the SDO pin on each
falling edge of SCK. The internally generated serial clock
is output to the SCK pin. This signal may be used to shift
the conversion result into external circuitry. EOC can be
latched on the first rising edge of SCK and the last bit of
the conversion result can be latched on the 32nd rising
edge of SCK. After the 32nd rising edge, SDO goes HIGH
(EOC = 1) indicating a new conversion is in progress. SCK
remains HIGH during the conversion.
Figure 10. Internal Serial Clock, Continuous Operation
CS
SCK
SDI
SDO
BUSY
2444589 F10
CONVERSION
SLEEP
DATA OUTPUT
CONVERSION
MSB
BIT 28 BIT 27 BIT 26 BIT 25 BIT 24 BIT 23 BIT 22 BIT 21 BIT 20 BIT 19 BIT 0
LSB
SIG
BIT 29
“0”
BIT 30
EOC
BIT 31
1 0 EN SGL A2 A1 A0 OSR3 OSR2 OSR1 OSR0 TWOXODD
1 2 3 4 5 6 7 8 9 10 11 12 13 14 32
DON'T CAREDON'T CARE
V
CC
F
O
REF
+
REF
–
CH0
CH7
CH8
CH15
COM
SCK
SDI
SDO
CS
GND
28 35
29
30
8
15
16
23
7
38
37
1,4,5,6,31,32,33,39
36
34
REFERENCE
VOLTAGE
0.1V TO V
CC
ANALOG
INPUTS
2
= EXTERNAL OSCILLATOR
= INTERNAL OSCILLATOR
1µF
4.5V TO 5.5V
LTC2448
4-WIRE
SPI INTERFACE
•
•
•
•
•
•
•
•
•
•
•
•
BUSY