Datasheet

LTC2411/LTC2411-1
16
Figure 5. External Serial Clock, Single Cycle Operation
Table 4. LTC2411/LTC2411-1 Interface Timing Modes
Conversion Data Connection
SCK Cycle Output and
Configuration Source Control Control Waveforms
External SCK, Single Cycle Conversion External CS and SCK CS and SCK Figures 5, 6
External SCK, 2-Wire I/O External SCK SCK Figure 7
Internal SCK, Single Cycle Conversion Internal CS ↓ CS ↓ Figures 8, 9
Internal SCK, 2-Wire I/O, Continuous Conversion Internal Continuous Internal Figure 10
EOC
BIT 31
SDO
SCK
(EXTERNAL)
CS
TEST EOC
SUB LSBMSBSIG
BIT 0
LSB
BIT 5BIT 27 BIT 26BIT 28BIT 29BIT 30
SLEEP DATA OUTPUT CONVERSION
2411 F05
CONVERSION
Hi-ZHi-ZHi-Z
TEST EOCTEST EOC
V
CC
F
O
REF
+
REF
–
SCK
IN
+
IN
–
SDO
GND
CS
110
2
3
9
4
5
8
6
7
REFERENCE
VOLTAGE
0.1V TO V
CC
ANALOG INPUT RANGE
–0.5V
REF
TO 0.5V
REF
= 50Hz REJECTION (LTC2411)
= EXTERNAL OSCILLATOR
= 60Hz REJECTION (LTC2411)
= SIMULTANEOUS 50Hz/60Hz REJECTION (LTC2411-1)
V
CC
1µF
2.7V TO 5.5V
LTC2411/
LTC2411-1
3-WIRE
SPI INTERFACE
Finally, CS can be used to control the free-running modes
of operation, see Serial Interface Timing Modes section.
Grounding CS will force the ADC to continuously convert
at the maximum output rate selected by F
O
.
SERIAL INTERFACE TIMING MODES
The LTC2411/LTC2411-1’s 3-wire interface is SPI and
MICROWIRE compatible. This interface offers several
flexible modes of operation. These include internal/exter-
nal serial clock, 2- or 3-wire I/O, single cycle conversion.
The following sections describe each of these serial inter-
face timing modes in detail. In all these cases, the
converter can use the internal oscillator (F
O
= LOW or F
O
= HIGH) or an external oscillator connected to the F
O
pin.
Refer to Table␣ 4 for a summary.
External Serial Clock, Single Cycle Operation
(SPI/MICROWIRE Compatible)
This timing mode uses an external serial clock to shift out
the conversion result and a CS signal to monitor and
control the state of the conversion cycle, see Figure 5.
The serial clock mode is selected on the falling edge of CS.
To select the external serial clock mode, the serial clock pin
(SCK) must be LOW during each CS falling edge.
The serial data output pin (SDO) is Hi-Z as long as CS is
HIGH. At any time during the conversion cycle, CS may be
pulled LOW in order to monitor the state of the converter.
While CS is pulled LOW, EOC is output to the SDO pin.
EOC␣ =␣ 1 while a conversion is in progress and EOC = 0 if
the device is in the sleep state. Independent of CS, the
APPLICATIO S I FOR ATIO
WUUU