Datasheet

LTC2248/LTC2247/LTC2246
11
224876fa
UU
U
PI FU CTIO S
A
IN
+ (Pin 1): Positive Differential Analog Input.
A
IN
- (Pin 2): Negative Differential Analog Input.
REFH (Pins 3, 4): ADC High Reference. Short together and
bypass to pins 5, 6 with a 0.1µF ceramic chip capacitor as
close to the pin as possible. Also bypass to pins 5, 6 with
an additional 2.2µF ceramic chip capacitor and to ground
with a 1µF ceramic chip capacitor.
REFL (Pins 5, 6): ADC Low Reference. Short together and
bypass to pins 3, 4 with a 0.1µF ceramic chip capacitor as
close to the pin as possible. Also bypass to pins 3, 4 with
an additional 2.2µF ceramic chip capacitor and to ground
with a 1µF ceramic chip capacitor.
V
DD
(Pins 7, 32): 3V Supply. Bypass to GND with 0.1µF
ceramic chip capacitors.
GND (Pin 8): ADC Power Ground.
CLK (Pin 9): Clock Input. The input sample starts on the
positive edge.
SHDN (Pin 10): Shutdown Mode Selection Pin. Connect-
ing SHDN to GND and OE to GND results in normal
operation with the outputs enabled. Connecting SHDN to
GND and OE to V
DD
results in normal operation with the
outputs at high impedance. Connecting SHDN to V
DD
and
OE to GND results in nap mode with the outputs at high
impedance. Connecting SHDN to V
DD
and OE to V
DD
results in sleep mode with the outputs at high impedance.
OE (Pin 11): Output Enable Pin. Refer to SHDN pin
function.
D0 – D13 (Pins 12, 13, 14, 15, 16, 17, 18, 19, 22, 23, 24,
25, 26, 27): Digital Outputs. D13 is the MSB.
OGND (Pin 20): Output Driver Ground.
OV
DD
(Pin 21): Positive Supply for the Output Drivers.
Bypass to ground with 0.1µF ceramic chip capacitor.
OF (Pin 28): Over/Under Flow Output. High when an over
or under flow has occurred.
MODE (Pin 29): Output Format and Clock Duty Cycle
Stabilizer Selection Pin. Connecting MODE to GND selects
offset binary output format and turns the clock duty cycle
stabilizer off. 1/3 V
DD
selects offset binary output format
and turns the clock duty cycle stabilizer on. 2/3 V
DD
selects
2’s complement output format and turns the clock duty
cycle stabilizer on. V
DD
selects 2’s complement output
format and turns the clock duty cycle stabilizer off.
SENSE (Pin 30): Reference Programming Pin. Connecting
SENSE to V
CM
selects the internal reference and a ±0.5V
input range. V
DD
selects the internal reference and a ±1V
input range. An external reference greater than 0.5V and
less than 1V applied to SENSE selects an input range of
±V
SENSE
. ±1V is the largest valid input range.
V
CM
(Pin 31): 1.5V Output and Input Common Mode Bias.
Bypass to ground with 2.2µF ceramic chip capacitor.
GND (Exposed Pad) (Pin 33): ADC Power Ground. The
exposed pad on the bottom of the package needs to be
soldered to ground.