Datasheet

LTC1850/LTC1851

18501f

Table 5

OPERATION MODE M1 M0 WR RD COMMENTS

Direct Address 0 0 0 OE Address and Configuration are Driven from External Pins

0 0 OE Address and Configuration are Latched on Rising Edge of WR or Falling Edge of CONVST

Scan 0 1 0 OE Address is Provided by Internal Scan Counter, Configuration is Driven from External Pins

0 1 OE Configuration is Latched on Rising Edge of WR or Falling Edge of CONVST

Program 1 0 1 Write Sequencer Location, WR Low Enables Inputs, Rising Edge of WR Latches Data and

Advances to Next Location

Readback 1 0 1 Read Sequencer Location, Falling Edge of RD Enables Output, Rising Edge of RD

Advances to Next Location

Sequence Run 1 1 X OE Run Programmed Sequence, Falling Edge of CONVST Starts Conversion and Advances to

Next Location

Sequence Run Mode

Once the sequencer is programmed, M0 is taken high.

BUSY will also come back high enabling CONVST and the

next falling CONVST will begin a conversion using the

MUX address and input configuration stored in location

0000 of the sequencer memory. After each conversion, the

sequencer pointer is advanced by one and the MUX

address (the actual channel or channels being converted,

not the sequencer pointer) for the present conversion is

available on the address output pins along with the con-

version result. When the sequencer finishes converting

the last programmed location, the sequencer pointer will

return to location 0000 for the next conversion. The

sequencer will also reset to location 0000 anytime the M1

or M0 pin changes state.

The contents of the sequencer memory will be retained as

long as power is continuously applied to the part. This

allows the user to switch from Sequence Run mode to

either Direct Address or Scan Mode and back without

losing the programmed sequence. The part can also be

disabled using CS or shutdown in Nap or Sleep mode

without losing the programmed sequence. Table 5 out-

lines the operational modes of the

LTC1850/

LTC1851.

Figures 11 and 12 show the timing diagrams for writing to,

reading from and running a sequence with the LTC1850/

LTC1851.

APPLICATIO S I FOR ATIO

WUUU