Datasheet

11
LTC1657/LTC1657L
Rail-to-Rail Output Considerations
In any rail-to-rail DAC, the output swing is limited to
voltages within the supply range.
If the DAC offset is negative, the output for the lowest
codes limits at 0V as shown in Figure 1b.
Similarly, limiting can occur near full scale when the REF
pin is tied to V
CC
/2. If V
REF
= V
CC
/2 and the DAC full-scale
error (FSE) is positive, the output for the highest codes
limits at V
CC
as shown in Figure 1c. No full-scale limiting
can occur if V
REF
is less than (V
CC
– FSE)/2.
Offset and linearity are defined and tested over the region
of the DAC transfer function where no output limiting can
occur.
Figure 2. Effects of Rail-to-Rail Operation On a DAC Transfer Curve. (a) Overall Transfer Function (b) Effect of Negative
Offset for Codes Near Zero Scale (c) Effect of Positive Full-Scale Error for Input Codes Near Full Scale When V
REF
= V
CC
/2
1657 F02
INPUT CODE
(b)
OUTPUT
VOLTAGE
NEGATIVE
OFFSET
0V
327680 65535
INPUT CODE
OUTPUT
VOLTAGE
(a)
V
REF
= V
CC
/2
V
CC
V
CC
V
REF
= V
CC
/2
(c)
INPUT CODE
OUTPUT
VOLTAGE
POSITIVE
FSE
APPLICATIO S I FOR ATIO
WUUU