Datasheet

ManualsBrandsLINEAR TECHNOLOGY ManualsData collecting ICsData acquisition IC - AD converter (ADC) External , Internal MSOP 10 EP

LTC1403-1/LTC1403A-1

14031fc

APPLICATIONS INFORMATION

; —————————dummy bsend return————————————

bsend return _ enable ;this is also a dummy return to dene bsend

;in vector table le BVECTORS.ASM

; ——————————— end ISR ——————————————

.copy “c:\dskplus\1403\s2k14ini.asm” ;initialize buffered serial port

.space 16*32 ;clear a chunk at the end to mark the end

;======================================================================

;

; VECTORS

;

;======================================================================

.sect “vectors” ;The vectors start here

.copy “c:\dskplus\1403\bvectors.asm” ;get BSP vectors

.sect “buffer” ;Set address of BSP buffer for clearing

.space 16*0x800

.sect “result” ;Set address of result for clearing

.space 16*0x800

.end

; ***************************************************************************

; File: BVECTORS.ASM -> Vector Table for the ‘C54x DSKplus 10.Jul.96

; BSP vectors and Debugger vectors

; TDM vectors just return

; ***************************************************************************

; The vectors in this table can be congured for processing external and

; internal software interrupts. The DSKplus debugger uses four interrupt

; vectors. These are RESET, TRAP2, INT2, and HPIINT.

; * DO NOT MODIFY THESE FOUR VECTORS IF YOU PLAN TO USE THE DEBUGGER *

;

; All other vector locations are free to use. When programming always be sure

; the HPIINT bit is unmasked (IMR=200h) to allow the communications kernel and

; host PC interact. INT2 should normally be masked (IMR(bit 2) = 0) so that the

; DSP will not interrupt itself during a HINT. HINT is tied to INT2 externally.

;

.title “Vector Table”

.mmregs

reset goto #80h ;00; RESET * DO NOT MODIFY IF USING DEBUGGER *

nop

nmi return _ enable ;04; non-maskable external interrupt

nop

trap2 goto #88h ;08; trap2 * DO NOT MODIFY IF USING DEBUGGER *

nop

.space 52*16 ;0C-3F: vectors for software interrupts 18-30

int0 return _ enable ;40; external interrupt int0

nop

int1 return _ enable ;44; external interrupt int1

nop