Datasheet

3
LTC1151
1151fa
E
LECTR
IC
AL C CHARA TERIST
ICS
LTC1151C
PARAMETER CONDITIONS MIN TYP MAX UNITS
Maximum Output Voltage Swing R
L
= 10k, T
A
= 25°C ±13.5 ±14.50 V
R
L
= 10k ● +10.5/–13.5 V
R
L
= 100k ±14.95 V
Slew Rate R
L
= 10k, C
L
= 50pF 2.5 V/µs
Gain-Bandwidth Product 2 MHz
Supply Current per Amplifier No Load, T
A
= 25°C 0.9 1.5 mA
No Load ● 2.0 mA
Internal Sampling Frequency 1000 Hz
Input Offset Voltage T
A
= 25°C (Note 3) ±0.05 ±5 µV
Average Input Offset Drift (Note 3) ● ±0.01 ±0.05 µV/°C
Long Term Offset Voltage Drift 50 nV/√mo
Input Offset Current T
A
= 25°C ±10 100 pA
Input Bias Current T
A
= 25°C ±550 pA
Input Noise Voltage R
S
= 100Ω, 0.1Hz to 10Hz 2.0 µV
P-P
R
S
= 100Ω, 0.1Hz to 1Hz 0.7 µV
P-P
Input Noise Current f = 10Hz (Note 4) 1.3 fA/√Hz
Input Voltage Range Positive 2.7 3.2 V
Negative 0 –0.3 V
Common Mode Rejection Ratio V
CM
= 0V to 2.7V 110 dB
Power Supply Rejection Ratio V
S
= ±2.375V to ±16V ● 110 130 dB
Large-Signal Voltage Gain R
L
= 10k, V
OUT
= 0.3V to 4.5V ● 115 140 dB
Maximum Output Voltage Swing R
L
= 10k to GND 4.85 V
R
L
= 100k to GND 4.97 V
Slew Rate R
L
= 10k, C
L
= 50pF 1.5 V/µs
Gain Bandwidth Product 1.5 MHz
Supply Current per Amplifier No Load, T
A
= 25°C 0.5 1.0 mA
● 1.5 mA
Internal Sampling Frequency 750 Hz
Note 1: Absolute Maximum Ratings are those values beyond which the life
of a device may be impaired.
Note 2: Connecting any terminal to voltages greater than V
+
or less than V
–
may cause destructive latch-up. It is recommended that no sources
operating from external supplies be applied prior to power-up of the
LTC1151.
Note 3: These parameters are guaranteed by design. Thermocouple effects
preclude measurement of these voltage levels in high speed automatic test
systems. V
OS
is measured to a limit determined by test equipment
capability.
Note 4: Current Noise is calculated from the formula:
I
N
= √(2q • I
b
)
where q = 1.6 × 10
–19
Coulomb.
The ● denotes the specifications which apply over the full operating
temperature range, otherwise specifications are at T
A
= 25°C. V
S
= ±15V, unless otherwise specified.
The
● denotes the specifications which apply over the full operating temperature range, otherwise specifications are at T
A
= 25°C. V
S
= 5V, unless otherwise specified.