Datasheet

LT8705
23
8705fb
For more information www.linear.com/LT8705
Final R
SENSE
Value: The final R
SENSE
value should be
lower than both R
SENSE(MAX,BOOST)
and R
SENSE(MAX,BUCK)
.
A margin of 30% or more is recommended.
Figure 8 shows approximately how the maximum output
current and maximum inductor current would vary with
V
IN
/V
OUT
while all other operating parameters remain
constant (frequency = 350kHz, inductance = 10μH, R
SENSE
=
10mΩ). This graph is normalized and accounts for changes
in maximum current due to the slope compensation ramps
and the effects of changing ripple current. The curve is
theoretical, but can be used as a guide to predict relative
changes in maximum output and inductor current over a
range of V
IN
/V
OUT
voltages.
Reverse Current Limit
When the forced continuous mode is selected (MODE
pin low), inductor current is allowed to reverse directions
and flow from the V
OUT
side to the V
IN
side. This can lead
to current sinking from the output and being forced into
the input. The reverse current is at a maximum magni
-
tude when V
C
is lowest. The graph of Minimum Inductor
Current Sense Voltage in FCM in the Typical Performance
Ch
aracteristics section can help to determine the maximum
reverse current capability.
Inductor Selection
For high efficiency, choose an inductor with low core
loss, such as ferrite. Also, the inductor should have low
DC resistance to reduce the I
2
R losses, and must be able
to handle the peak inductor current without saturating. To
minimize radiated noise, use a toroid, pot core or shielded
bobbin inductor.
The operating frequency and inductor selection are
interrelated in that higher operating frequencies allow
the use of smaller inductor and capacitor values. The
following sections discuss several criteria to consider
when choosing an inductor value. For optimal perfor
-
mance, choose an inductor that meets all of the following
criteria.
Inductor Selection: Adequate Load Current in the
Boost Region
Sm
all value inductors result in increased ripple cur
-
rents and thus, due to the limited peak inductor current,
dec
rease the maximum average current that can be
provided to the load (I
OUT
) while operating in the boost
region.
applicaTions inForMaTion
Figure 8. Currents vs V
IN
/V
OUT
Ratio
V
IN
/V
OUT
(V/V)
NORMALIZED CURRENT
1.0
0.8
0.6
8705 F08
0
0.4
0.2
10
0.1 1
MAXIMUM
INDUCTOR
CURRENT
MAXIMUM
OUTPUT
CURRENT