Datasheet

LT3684
13
3684f
When choosing a capacitor, look carefully through the
data sheet to fi nd out what the actual capacitance is under
operating conditions (applied voltage and temperature).
A physically larger capacitor, or one with a higher voltage
rating, may be required. High performance tantalum or
electrolytic capacitors can be used for the output capacitor.
Low ESR is important, so choose one that is intended for
use in switching regulators. The ESR should be specifi ed
by the supplier, and should be 0.05Ω or less. Such a
capacitor will be larger than a ceramic capacitor and will
have a larger capacitance, because the capacitor must be
large to achieve low ESR. Table 2 lists several capacitor
vendors.
Catch Diode
The catch diode conducts current only during switch off
time. Average forward current in normal operation can
be calculated from:
I
D(AVG)
= I
OUT
(V
IN
– V
OUT
)/V
IN
where I
OUT
is the output load current. The only reason to
consider a diode with a larger current rating than necessary
for nominal operation is for the worst-case condition of
shorted output. The diode current will then increase to the
typical peak switch current. Peak reverse voltage is equal
to the regulator input voltage. Use a diode with a reverse
voltage rating greater than the input voltage. Table 3 lists
several Schottky diodes and their manufacturers.
Table 3. Diode Vendors
PART NUMBER
V
R
(V)
I
AVE
(A)
V
F
AT 1A
(mV)
V
F
AT 2A
(mV)
On Semicnductor
MBRM120E
MBRM140
20
40
1
1
530
550
595
Diodes Inc.
B120
B130
B220
B230
DFLS240L
20
30
20
30
40
1
1
2
2
2
500
500
500
500
500
International Rectifi er
10BQ030
20BQ030
30
30
1
2
420 470
470
Frequency Compensation
The LT3684 uses current mode control to regulate the
output. This simplifi es loop compensation. In particular, the
LT3684 does not require the ESR of the output capacitor
for stability, so you are free to use ceramic capacitors to
achieve low output ripple and small circuit size. Frequency
compensation is provided by the components tied to the
V
C
pin, as shown in Figure 2. Generally a capacitor (C
C
)
and a resistor (R
C
) in series to ground are used. In addi-
tion, there may be lower value capacitor in parallel. This
capacitor (C
F
) is not part of the loop compensation but
is used to fi lter noise at the switching frequency, and is
required only if a phase-lead capacitor is used or if the
output capacitor has high ESR.
VENDOR PHONE URL PART SERIES COMMANDS
Panasonic [phone] www.panasonic.com Ceramic,
Polymer,
Tantalum
EEF Series
Kemet [phone] www.kemet.com Ceramic,
Tantalum T494, T495
Sanyo [phone] www.sanyovideo.com Ceramic,
Polymer,
Tantalum
POSCAP
Murata [phone] www.murata.com Ceramic
AVX www.avxcorp.com Ceramic,
Tantalum TPS Series
Taiyo Yuden [phone] www.taiyo-yuden.com Ceramic
Table 2. Capacitor Vendors
APPLICATIONS INFORMATION