Datasheet

LT3518
4
3518fe
ELECTRICAL CHARACTERISTICS
The l denotes the specifi cations which apply over the full operating
temperature range, otherwise specifi cations are at T
A
= 25°C. (Note 2) V
IN
= 5V, SHDN = 5V, PWM = 5V unless otherwise noted.
Note 1: Stresses beyond those listed under Absolute Maximum Ratings
may cause permanent damage to the device. Exposure to any Absolute
Maximum Rating condition for extended periods may affect device
reliability and lifetime.
Note 2: The LT3518E is guaranteed to meet performance specifi cations
from 0°C to 125°C junction temperature. Specifi cations over the –40°C
to 125°C operating junction temperature range are assured by design,
characterization and correlation with statistical process controls. The
LT3518I is guaranteed over the full –40°C to 125°C operating junction
temperature range. The LT3518H is guaranteed over the full –40°C to
150°C operating junction temperature range. Operating lifetime is derated
at junction temperatures greater than 125°C.
Note 3: Absolute maximum voltage at V
IN
, SHDN, PWM and TGEN pins
is 40V for nonrepetitive 1 second transients and 30V for continuous
operation.
Note 4: This IC includes overtemperature protection that is intended
to protect the device during momentary overload conditions. Junction
temperature will exceed the maximum operating junction temperature
when overtemperature protection is active. Continuous operation above
the specifi ed maximum operating junction temperature may impair device
reliability.
PARAMETER CONDITIONS MIN TYP MAX UNITS
TGEN Input High Voltage 1.5 V
TGEN Input Low Voltage 0.4 V
TGEN Pin Bias Current TGEN = 5V 100 200 µA
V
REF
Pin Voltage I
REF
= –100µA
l
1.96 2 2.04 V
V
REF
Pin Voltage Line Regulation 3V < V
IN
< 40V 0.03 %/V
Gate Turn-On Delay C
LOAD
= 1nF Between ISP and TG 200 ns
Gate Turn-Off Delay C
LOAD
= 1nF Between ISP and TG 200 ns
Top Gate Drive V
GS
(V
ISP
– V
TG
)V
ISP
= 24V, TGEN = 5V
PWM = 0V
7
0 0.3
V
V