Datasheet
11
LT2078/LT2079
20789fa
APPLICATIONS INFORMATION
WUU
U
1. When the input is more than a diode drop below ground,
unlimited current will flow from the substrate (V
–
terminal) to the input. This can destroy the unit. On the
LT2078/LT2079, resistors in series with the input protect
the devices even when the input is 5V below ground.
2. When the input is more than 400mV below ground (at
25°C), the input stage saturates and phase reversal
occurs at the output. This can cause lockup in servo
systems. Due to a unique phase reversal protection cir-
cuitry, the LT2078/LT2079 output does not reverse, as
illustrated in Figure 2, even when the inputs are at –1V.
Distortion
There are two main contributors of distortion in op amps:
distortion caused by nonlinear common mode rejection
and output crossover distortion as the output transitions
from sourcing to sinking current. The common mode
rejection of the LT2078/LT2079 is very good, typically
108dB. Therefore, as long as the input operates in the
normal common mode range, there will be very little
common mode induced distortion. If the op amp is oper-
ating inverting there is no common mode induced distor-
tion. Crossover distortion will increase as the output load
resistance decreases. For the lowest distortion the LT2078/
LT2079 should be operated with the output always sourc-
ing current, this is usually accomplished by putting a
resistor from the output to V
–
. In an inverting configura-
tion with no load, the output will source and sink current
through the feedback resistor. High value feedback resis-
tors will reduce crossover distortion and maintain
micropower operation.
Matching Specifications
In many applications the performance of a system de-
pends on the matching between two op amps, rather than
Figure 2. Voltage Follower with Input Exceeding the Negative Common Mode Range (V
S
= 5V, 0V)
2V
0V
6V
P-P
INPUT 1ms/DIV
–1V TO 5V
LT2078/79 • F01a
1ms/DIV
LT2078/LT2079 NO PHASE REVERSAL
LT2078/79 • F01C
2V
0V
4V
1ms/DIV
OP-90 EXHIBITS OUTPUT PHASE REVERSAL
LT2078/79 • F01b
2V
0V
4V
4V
Table 1
LT2078AC/LT2079AC/LT2078AI/LT2079AI LT2078C/LT2079C/LT2078I/LT2079I
PARAMETER 50% YIELD 98% YIELD 50% YIELD 98% YIELD UNITS
V
OS
Match, ∆V
OS
LT2078 30 110 50 190 µV
LT2079 40 150 50 250 µV
Temperature Coefficient ∆V
OS
0.5 1.2 0.6 1.8 µV/°C
Average Noninverting I
B
68610 nA
Match of Noninverting I
B
0.12 0.4 0.15 0.5 nA
CMRR Match 120 100 117 97 dB
PSRR Match 117 105 117 102 dB