Datasheet
LT1210
4
1210fb
For more information www.linear.com/LT1210
elecTrical characTerisTics
The l denotes the specifications which apply over the full operating
temperature range, otherwise specifications are at T
A
= 25°C. V
CM
= 0V, ± 5V ≤ V
S
≤ ± 15V, pulse tested, V
SD
= 0V, unless
otherwise noted.
Note 1: Stresses beyond those listed under Absolute Maximum Ratings
may cause permanent damage to the device. Exposure to any Absolute
Maximum Rating condition for extended periods may affect device
reliability and lifetime.
Note 2: A heat sink may be required to keep the junction temperature
below the Absolute Maximum rating. Applies to short circuits to ground
only. A short circuit between the output and either supply may permanently
damage the part when operated on supplies greater than ±10V.
Note 3: The LT1210C/LT1210I are guaranteed functional over the
temperature range of –40°C to 85°C.
Note 4: The LT1210C is guaranteed to meet specified performance from
0°C to 70°C. The LT1210C is designed, characterized and expected to meet
specified performance from –40°C to 85°C but not tested or QA sampled
at these temperatures. The LT1210I is guaranteed to meet specified
performance from –40°C to 85°C.
Note 5: SO package is recommended for ±5V supplies only, as the power
dissipation of the SO package limits performance on higher supplies.
For supply voltages greater than ±5V, use the TO-220 or DD package.
See “Thermal Considerations” in the Applications Information section for
details on calculating junction temperature. If the maximum dissipation of
the package is exceeded, the device will go into thermal shutdown.
Note 6: R
SD
is connected between the Shutdown pin and ground.
Note 7: Slew rate is measured at ±5V on a ±10V output signal while
operating on ±15V supplies with R
F
= 1.5k, R
G
= 1.5k and R
L
= 400Ω.
Note 8: NTSC composite video with an output level of 2V.
SYMBOL PARAMETER CONDITIONS MIN TYP MAX UNITS
SR Slew Rate (Note 7)
Slew Rate (Note 5)
T
A
= 25°C, A
V
= 2, R
L
= 400Ω
T
A
= 25°C, A
V
= 2, R
L
= 10Ω
400 900
900
V/µs
V/µs
Differential Gain (Notes 5, 8) V
S
= ±15V, R
F
= 750Ω, R
G
= 750Ω, R
L
= 15Ω 0.3 %
Differential Phase (Notes 5, 8) V
S
= ±15V, R
F
= 750Ω, R
G
= 750Ω, R
L
= 15Ω 0.1 DEG
BW Small-Signal Bandwidth A
V
= 2, V
S
= ±15V, Peaking ≤ 1dB,
R
F
= R
G
= 680Ω, R
L
= 100Ω
55 MHz
A
V
= 2, V
S
= ±15V, Peaking ≤ 1dB,
R
F
= R
G
= 576Ω, R
L
= 10Ω
35 MHz
Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.