Datasheet

LT1124/LT1125
6
11245fe
TYPICAL PERFORMANCE CHARACTERISTICS
0.1Hz to 10Hz Voltage Noise 0.01Hz to 1Hz Voltage Noise Voltage Noise vs Frequency
Current Noise vs Frequency
Input Bias or Offset Current
vs Temperature
voltage exceeds ±1.4V, the input current should be limited to 25mA.
Note 7: Slew rate is measured in A
V
= –1; input signal is ±7.5V, output
measured at ±2.5V.
Note 8: 0.1Hz to 10Hz noise can be inferred from the 10Hz noise voltage
density test. See the test circuit and frequency response curve for 0.1Hz
to 10Hz tester in the Applications Information section of the LT1007 or
LT1028 data sheets.
Note 9: This parameter is guaranteed but not tested.
Note 10: The LT1124C/LT1125C and LT1124AC/LT1125AC are guaranteed
to meet specifi ed performance from 0°C to 70°C and are designed,
characterized and expected to meet these extended temperature limits,
but are not tested at –40°C and 85°C. The LT1124AI and LT1124I are
guaranteed to meet the extended temperature limits.
Note 1: Stresses beyond those listed under Absolute Maximum Ratings
may cause permanent damage to the device. Exposure to any Absolute
Maximum Rating condition for extended periods may affect device
reliability and lifetime.
Note 2: Typical parameters are defi ned as the 60% yield of parameter
distributions of individual amplifi ers; i.e., out of 100 LT1125s (or 100
LT1124s) typically 240 op amps (or 120) will be better than the indicated
specifi cation.
Note 3: This parameter is 100% tested for each individual amplifi er.
Note 4: This parameter is sample tested only.
Note 5: This parameter is not 100% tested.
Note 6: The inputs are protected by back-to-back diodes. Current limiting
resistors are not used in order to achieve low noise. If differential input
ELECTRICAL CHARACTERISTICS
TIME (SECONDS)
0
VOLTAGE NOISE (40nV/DIV)
26810
1124/25 G01
4
TIME (SECONDS)
0
VOLTAGE NOISE (40nV/DIV)
20 60 80 100
1124/25 G02
40
FREQUENCY (Hz)
3
RMS VOLTAGE NOISE DENSITY (nV/√Hz)
10
30
100
0.1 10 100 1000
1124/25 G03
1
1.0
MAXIMUM
TYPICAL
V
S
= ±15V
T
A
= 25°C
1/f CORNER
2.3Hz
FREQUENCY (Hz)
0.3
RMS CURRENT NOISE DENSITY (pA/√Hz)
1.0
3.0
10.0
10 1k 10k
1124 G04
0.1
100
V
S
= ±15V
T
A
= 25°C
TYPICAL
MAXIMUM
1/f CORNER
100Hz
TEMPERATURE (°C)
–75
0
INPUT BIAS OR OFFSET CURRENT (nA)
10
20
30
–50 25 75 125
1124/25 G05
–25 0 50 100
LT1124M/LT1125M
LT1124AM/LT1125AM
V
S
= ±15V