Datasheet

3
L T 1111
1111fd
SYMBOL PARAMETER CONDITIONS MIN TYP MAX UNITS
I
FB
Feedback Pin Bias Current LT1111, V
FB
= 0V 70 120 nA
I
SET
Set Pin Bias Current V
SET
= V
REF
70 300 nA
V
OL
Gain Block Output Low I
SINK
= 300µA, V
SET
= 1.00V 0.15 0.4 V
Reference Line Regulation 5V V
IN
30V 0.02 0.075 %/V
2V V
IN
5V 0.20 0.400 %/V
A
V
Gain Block Gain R
L
= 100k (Note 4) 1000 6000 V/V
I
LIM
Current Limit 220 from I
LIM
to V
IN
400 mA
Current Limit Temperature Coefficient 0.3 %/°C
Switch OFF Leakage Current Measured at SW1 Pin, V
SW1
= 12V 1 10 µA
Maximum Excursion Below GND I
SW1
10µA, Switch OFF 400 350 mV
E
LECTR
IC
AL C CHARA TERIST
ICS
LT1111C
SYMBOL PARAMETER CONDITIONS MIN TYP MAX UNITS
I
Q
Quiescent Current Switch OFF 300 450 µA
f
OSC
Oscillator Frequency 54 72 95 kH
DC Duty Cycle: Step-Up Mode Full Load 43 50 59 %
Step-Down Mode
24 34 50 %
t
ON
Switch ON Time: Step-Up Mode I
LIM
Tied to V
IN
5.0 7 9.0 µs
Step-Down Mode V
OUT
= 5V, V
IN
= 12V 3.3 5 7.8 µs
Reference Line Regulation 2V V
IN
5V 0.2 0.7 %/V
V
SAT
SW Saturation Voltage, Step-Up Mode V
IN
= 3V, I
SW
= 650mA 0.5 0.65 V
SW Saturation Voltage, Step-Down Mode V
IN
= 12V, I
SW
= 650mA 1.1 1.50 V
The denotes the specifications which apply over the full operating temperature range, otherwise specifications are at T
A
= 25°C.
V
IN
= 3V, 0°C T
A
70°C unless otherwise noted.
Note 1: Absolute Maximum Ratings are those values beyond which the life
of a device may be impaired.
Note 2: This specification guarantees that both the high and low trip points
of the comparator fall within the 1.20V to 1.30V range.
Note 3: The output voltage waveform will exhibit a sawtooth shape due to
the comparator hysteresis. The output voltage on the fixed output versions
will always be within the specified range.
Note 4: 100k resistor connected between a 5V source and the A0 pin.
The denotes the specifications which apply over the full operating
temperature range, otherwise specifications are at T
A
= 25°C.V
IN
= 3V, Military or Commercial Version