Datasheet

LTC2484
24
2484fd
APPLICATIONS INFORMATION
Internal Serial Clock, 3-Wire I/O,
Continuous Conversion
This timing mode uses a 3-wire interface. The conversion
result is shifted out of the device by an internally gener-
ated serial clock (SCK) signal, see Figure 10. CS may be
permanently tied to ground, simplifying the user interface
or transmission over an isolation barrier.
The internal serial clock mode is selected at the end of the
power-on reset (POR) cycle. The POR cycle is concluded
approximately 1ms after V
CC
exceeds 2V. An internal weak
pull-up is active during the POR cycle; therefore, the internal
serial clock timing mode is automatically selected if SCK
is not externally driven LOW (if SCK is loaded such that
the internal pull-up cannot pull the pin HIGH, the external
SCK mode will be selected).
During the conversion, the SCK and the serial data output
pin (SDO) are HIGH (EOC = 1). Once the conversion is
complete, SCK and SDO go LOW (EOC = 0) indicating
the conversion has fi nished and the device has entered
the low power sleep state. The part remains in the sleep
state a minimum amount of time (1/2 the internal SCK
period) then immediately begins outputting data. The
data input/output cycle begins on the fi rst rising edge of
SCK and ends after the 32nd rising edge. The input data
is then shifted in via the SDI pin on the rising edge of
SCK (including the fi rst rising edge) and the output data
is shifted out of the SDO pin on each falling edge of SCK.
The internally generated serial clock is output to the SCK
pin. This signal may be used to shift the conversion result
into external circuitry. EOC can be latched on the fi rst ris-
ing edge of SCK and the last bit of the conversion result
can be latched on the 32nd rising edge of SCK. After the
32nd rising edge, SDO goes HIGH (EOC = 1) indicating a
new conversion is in progress. SCK remains HIGH during
the conversion.
EN GS2 GS1 GS0 IM FA FB SPD
SDI*
DON’T CARE DON’T CARE
SDO
SCK
(INTERNAL)
CS
LSBMSBSIG
BIT 4 BIT 0
IM
BIT 19 BIT 18 BIT 17 BIT 16BIT 20BIT 21BIT 22
EOC
BIT 23
DATA OUTPUT CONVERSIONCONVERSION
2484 F10
V
CC
f
O
V
REF
IN
+
IN
–
SCK
SDI
SDO
CS
GND
210
INT/EXT CLOCK
3
4
5
9
7
8
6
1
REFERENCE
VOLTAGE
0.1V TO V
CC
ANALOG
INPUT
1μF
2.7V TO 5.5V
LTC2484
3-WIRE
SPI INTERFACE
10k
V
CC
Figure 10. Internal Serial Clock, CS = 0 Continuous Operation