Datasheet

LTC2205-14
6
220514fb
Note 1: Stresses beyond those listed under Absolute Maximum Ratings
may cause permanent damage to the device. Exposure to any Absolute
Maximum Rating condition for extended periods may affect device
reliability and lifetime.
Note 2: All voltage values are with respect to GND, with GND and OGND
shorted (unless otherwise noted).
Note 3: When these pin voltages are taken below GND or above V
DD
, they
will be clamped by internal diodes. This product can handle input currents
of greater than 100mA below GND or above V
DD
without latchup.
Note 4: V
DD
= 3.3V, f
SAMPLE
= 65MHz differential ENC
+
/ENC
–
= 2V
P-P
sine
wave with 1.6V common mode, input range = 2.25V
P-P
with differential
drive (PGA = 0), unless otherwise specifi ed.
Note 5: Integral nonlinearity is defi ned as the deviation of a code from
a “best fi t straight line” to the transfer curve. The deviation is measured
from the center of the quantization band.
Note 6: Offset error is the offset voltage measured from –1/2LSB when the
output code fl ickers between 00 0000 0000 0000 and 11 1111 1111 1111
in 2’s complement output mode.
Note 7: Guaranteed by design, not subject to test.
The ● denotes the specifi cations which apply over the full operating temperature
range, otherwise specifi cations are at T
A
= 25°C. (Note 4)
SYMBOL PARAMETER CONDITIONS MIN TYP MAX UNITS
f
S
Sampling Frequency
l
1 65 MHz
t
L
ENC Low Time Duty Cycle Stabilizer Off (Note 7)
Duty Cycle Stabilizer On (Note 7)
l
l
6.40
4.60
7.69
7.69
500
500
ns
ns
t
H
ENC High Time Duty Cycle Stabilizer Off (Note 7)
Duty Cycle Stabilizer On (Note 7)
l
l
6.40
4.60
7.69
7.69
500
500
ns
ns
t
AP
Sample-and-Hold
Aperture Delay
0.7 ns
t
D
ENC to DATA Delay (Note 7)
l
1.3 2.7 4.0 ns
t
C
ENC to CLKOUT Delay (Note 7)
l
1.3 2.7 4.0 ns
t
SKEW
DATA to CLKOUT Skew (t
D
– t
C
) (Note 7)
l
–0.6 0 0.6 ns
t
OE
DATA Access Time
Bus Relinquish Time
CL = 5pf (Note 7)
(Note 7)
l
l
5
5
15
15
ns
ns
Pipeline
Latency
7 Cycles
TIMING CHARACTERISTICS