Datasheet

LTM4628
14
4628fe
For more information www.linear.com/LTM4628
onto incoming clock phase as well. The CLKOUT signal
can be connected to the MODE_PLLIN pin of the following
stage to
line up both the frequency and the phase of the
entire
system. Tying the PHASMD pin to INTV
CC
, SGND,
or left floating generates a phase difference (between
MODE_PLLIN and CLKOUT) of 120 degrees, 60 degrees,
or 90 degrees respectively. A total of 12 phases can be
cascaded to run simultaneously with respect to each other
by programming the PHASMD pin of each LTM4628 chan
-
nel to different levels. Figure 3 shows a 2-phase design,
4-phase design and a 6-phase design example for clock
phasing with the PHASMD table.
A multiphase power supply significantly reduces the
amount of ripple current in both the input and output ca
-
pacitors. The
RMS input ripple current is reduced by, and
the effective ripple frequency is multiplied by, the number
of phases used (assuming that the input voltage is greater
APPLICATIONS INFORMATION
than the number of phases used times the output voltage).
The output ripple amplitude is also reduced by the number
of phases used when all of the outputs are tied together
to achieve a single high output current design.
The LTM4628 device is
an inherently
current mode con-
trolled device,
so parallel modules will have very good
current sharing. This will balance the thermals on the
design. Figure 31 shows an example of parallel operation
and pin connection.
Input RMS Ripple Current Cancellation
Application Note 77 provides a detailed explanation of
multiphase operation. The input RMS ripple current cancel
-
lation mathematical derivations
are presented, and a graph
is displayed representing the RMS ripple current reduction
as a function of the number of interleaved phases. Figure 4
shows this graph.
Figure 4. Input RMS Current Ratios to DC Load Current as a Function of Duty Cycle
DUTY CYCLE (V
OUT
/V
IN
)
0.1 0.15 0.2 0.25 0.3 0.35 0.4 0.45 0.5 0.55 0.6 0.65 0.7 0.75 0.8
0.85 0.9
0.60
0.55
0.50
0.45
0.40
0.35
0.30
0.25
0.20
0.15
0.10
0.05
0
4628 F04
RMS INPUT RIPPLE CURRENT
DC LOAD CURRENT
6-PHASE
4-PHASE
3-PHASE
2-PHASE
1-PHASE