Setup Guide

MIDI Setup Guide: MIDI Control with 3rd Party Applications
4•24
• Set Footswitch 1’s To MIDI Out to “MMC” and the MIDI CC/Action to “Record Punch (Pro
Tools)”.
• Set Footswitch 2’s To MIDI Out to “MMC” and the MIDI CC/Action to “Stop”. (Or, alternatively,
you can choose whatever other two transport functions you prefer for these Footswitches).
• At the top right of the MIDI Controller Settings dialog, type in “PT-Transport” and click the
Save button to save these settings as a preset. The dialog should appear like this:
• Click Apply and then OK to exit.
Configure Pro Tools LE for Your Line 6 device
The next step is to make a few settings within Pro Tools to allow it to receive the MMC commands
from your KB37/UX2/UX8 device. Launch Pro Tools and open or create a new session. Then make the
following settings.
• Go to the Setup menu and select Peripherals.
• In the Peripherals dialog, choose the Machine Control screen and make the following settings:
• For MIDI Machine Control (Master) - check the Enable box, choose your KB37/UX2/
UX8 device, and set the ID to “125”. Keep the Preroll set to “90” frames.
• For MIDI Machine Control (Slave) - check the Enable box, and keep the ID set to “126”.
• Exit the Peripherals dialog.
Next, we need to access the small “Pro Tools” menu on the Transport...
In the Pro Tools - Transport sub-menu,
select “Pro Tools” so that it is checked.