User Manual
Amp, Cab & Mic Models
6•1
amp, cab & mic mOdelS
This chapter provides details on selecting & editing the exemplary HD Guitar Amp
& Preamp Models, all of which have been newly developed by our amazing team of
sound engineers for POD® HD Pro X! Also covered here are details on Speaker Cabs,
Mic Models and putting Amp Models to use.
Amp Model Positioning
Each Preset includes the ability to run one or two Amp or Preamp Models. Much like
each FX Block, the Amp Block can be repositioned using the MOVE button (please see
“Moving FX Blocks” on page 3•4 ). Here we’ll cover the impact on your signal ow
when placing the Amp in dierent positions.
*Note: Looking for a Mic Preamp Model? You can nd the Vintage Pre Model located within
the “Preamps+EQ” category of any FX Block. Having this Preamp Model within the FX Blocks
(rather than in the Amp Blocks) allows you the exibility of using it with or without the Amp
models, and positioning it anywhere in the signal chain. See “Preamp & EQ Models” on page
7•9
for more info.
Amps Within Paths A & B
You’ll nd that a number of the Factory Presets already utilize this type of conguration.
When moving the single Amp Model into the parallel Paths A/B, a 2nd Amp B Block
is automatically created in Path B. In this conguration, the top amp is referred to as
Amp A and the other Amp B.
Amp A Amp B
Amp Models within Paths A & B
Behaviors for this conguration are:
• Each Amp Block can be individually set to a dierent Amp or Preamp Model,*
edited and enabled/disabled.