User Manual

Features & Functionality
3•3
Amp Blocks
A single Amp Block can be placed in the “Pre” or “Post” signal ow positions, or within
parallel “Path A.” Or, two Amps can be used if positioned within Paths A & B, as shown
below. Much like FX Blocks, Amp Blocks can be toggled On/O and include several
editable parameters. But there’s quite a bit more available for Amps as well, so please
refer to the dedicated chapter “Amp, Cab & Mic Models” on page 6•1 for details!
A Preset with two Amp Blocks
Mixer Block
The Mixer is permanently positioned at the end of the parallel Paths A & B and provides
individual Level and Pan controls for each Paths’ output before fed to the “Post”
position. When the Mixer is selected in the Signal Flow View, its four parameters are
available at the bottom of the screen, accessible using the Multi-function Knobs 1-4.
The Signal Flow View with the Mixer Block selected, showing its 4 parameters