User Manual
Appendix B: FBV Foot Controllers
B•19
Controlling Amp & FX Parameters
Conguring the Expression Pedal and Variax Knob controller assignments is done
within the Controller Assign screen. In the Signal Flow View, select the Amp or FX
Block for which you’d like to create a controller assignment, then double-press the
MOVE button. For our example, we’ll select our Delay FX block in the Signal Flow View
and congure it to be controlled via the EXP-1 Pedal:
Tip! Expression Pedal and Knob Controllers are capable of driving up to 50+ POD HD parameters
simultaneously, making it possible to morph between sounds with a single Exp. Pedal or Knob
move. Simply repeat the following steps to assign a common Controller to multiple parameters
within the same Preset.
ENTER
DBL PRESS TO ASSIGN CTL
MOVE
AMP & FX ON / OFF
Note: When a Controller is assigned to any FX Model parameter, manually editing this parameter’s
value will result in changing the Controller’s MIN or MAX value. For example, if the EXP-1 Pedal
Controller is assigned to a Wah FX Model’s Position parameter, select the Wah Model, go to its
Edit View screen, and select the Position parameter. If you turn multifunction knob #4 when the
Pedal is near the “heel” position, the MIN value is adjusted. If you turn the knob when the Pedal
is near the “Toe” position, the MAX value is adjusted.
The Controller Assign screen is then displayed specically for the selected Model. In
our example, it is the Digital Delay W/Modulation. Use the Multi-function Knobs 1-4 to
congure the controller assignment options.