User Manual
Looper Details
5•2
Looper Mode
You enter Looper mode by pressing and holding the TAP switch. In Looper mode, the six
A B switches control the Looper, enabling you to record and play back a loop while your
current Scene is active. Here are the details:
1
Looper Switch – when you press and hold the TAP switch for a few seconds it will
remain lit solid red, indicating the two rows of FX A & B switches will now control various
functions of the looper. You’ll also see LPR ON briefly displayed in the LCD. Your current
Scene will still be active, and the first effect in your Scene will be displayed in the LCD.
2
Record/Overdub – to record a guitar loop, step on this switch and the looper will
record up to 28 seconds of whatever you play. Step on it a second time and your recorded
loop will play back immediately, with Overdub mode activated (its LED will flash).
Overdubbing – once you have a loop recorded, you can layer an overdub with your
current loop at any time. Simply play back the loop and step on the Record/Overdub
switch. Your new live guitar will be recorded along with your previous guitar track.
Looper Levels – the Playback and Overdub Level of your loop will be determined by
the Looper Levels you set in Setup mode (see Chapter 2•2). Play Level is the volume
of your recorded loop in relation to your live guitar volume. Overdub Level is the level
of your loop that will be recorded each time the loop cycles in Overdub mode.
1
2
3 4
5
6
7