User Manual
Scene Mode Details
4•4
Manual Save
To see how Manual Save differs from Auto Save, let’s do a Factory Reset and start over.
If you have any special Scenes saved, you can defer this exercise until you back up your
Scenes. Assuming you’re okay to do a reset, press the 1B+2B switches simultaneously to
enter Setup mode. Navigate to the MIDI screen and turn the Model Select knob so it
displays RST FACT?
Now hold TAP and press down on the Model Select knob (you’ll see “Are You Sure?”).
Press Model Select again to confirm. After your M9 resets, enter Setup mode again (press
1B+2B), navigate to the Prefs LCD and select MNL SAVE under Scenes by turning Knob 2.
Now repeat the same steps you did in the Auto Save exercise. Enter Scene Select mode
(3A+Tap), select Scene 2A, then switch on all the B switches to change the sound of the
Scene. Enter Scene Select mode again, select Scene 1B for a moment, re-enter Scene
Select mode and select Scene 2A again. Now play your guitar - you’ll hear Reverse Delay.
Notice all the A switches are lit this time. Scene 2A did not retain the changes you made.
In Manual Save mode, every time you select a Scene, it will be recalled exactly the same
way the next time you select it, even if you make temporary changes to it.
DECAY V. 2.00
CONTRAST
THRESH
MIDI Gate Display
RST FACT?
CH 1
REL
1>2>3
DIM ON
TRUE BYP
Prefs Scenes
DSP BYP
3>2>1
DIM OFF
POTS SCENE
ABS
MOMEN
MNL SAVE
AUTOSAVE
LATCH
POTS
SCENE