User Manual
Scene Mode Details
4•2
• When your Scene loads, you’ll see its first active effect displayed in the LCD. You
can tweak the parameters, if you like, or you can activate any of the bypassed FX.
• To see the next effect displayed in the LCD, press the Tap switch + the Model Select
knob simultaneously.
• If you’re in Auto Save mode, any changes you make to the Scene will be saved, like
a real pedal board. (see Page 3•2 for details on Auto Save vs. Manual Save)
• To select a new Scene, step on the 3A+Tap switches again and you’ll return to Scene
Select mode. Repeat the steps above and select a new Scene.
Latch Scene Mode
In Latch Scene mode the main difference is, when you enter Scene Select mode the 3 rows
of A & B Scene names remain displayed in the LCD.
Any Scene you select will be loaded in the usual way, but you won’t see its FX displayed in
the LCD. The advantage to Latch Scene mode is, you’re always only 1 switch away from
selecting a new Scene. So you can have 6 completely different setups ready to go, each
only 1 switch away. The disadvantage is, you can’t tweak or bypass any of the individual
FX directly, but you can bypass the current Scene by pressing its switch (its LED will flash).
A
B
B
A
B
A
TO CANCEL
Select
Scene
PRESS TAP