User Manual
Setup Details
2•6
• Turn the Model Select knob until “RST FACT?” is displayed.
• Press and hold TAP while you press down on the Model Select knob - “Reset To
Factory? Are You Sure” will be displayed.
• To initiate the Factory Reset, press down on the Model Select knob again.
All Factory defaults will be reset, including Scene Presets and Global settings.
Gate
Knobs 1 and 4 in the center of the LCD control the Global Noise Gate. When activated,
the Gate is in effect full time, for all your FX.
Knob 1 turns on the Gate and sets the Gate Threshold. Lower values make the Gate kick
in at quieter levels; higher values make it kick in at louder levels.
Knob 4 sets the Gate Decay. Higher levels result in a longer transition time from non-
gated to gated audio. Lower levels result in a quicker transition time.
Display
To adjust the contrast of the M9’s LCD display, use Knob 2. Set it to a value that looks
good to you. Settings from 30-50% usually work well.
Version
Your current Flash Memory version number is displayed in the lower right of the LCD.
This makes it easy to determine what version your M9 is currently running.
That basically covers the four Setup screens. When you’ve adjusted all the M9’s Setup
parameters to your liking, press 1B+2B switches to exit Setup mode. As mentioned
previously, the next time you power up your M9 all your Global settings will be recalled.
DECAY V. 2.00
CONTRAST
THRESH
MIDI Gate Display
RST FACT?
CH 1
RESET
RESET TO FACTORY?
ARE YOU SURE?