User Manual

Setup Details
2•2
Tempo, Expression Pedals
Press the Model Select knob and you’ll toggle to the second Setup screen, Tempo &
Espression Pedals. In the lower left of the LCD you’ll see a Tempo control, adjustable by
turning Knob 3. This sets the global Tempo for FX that don’t have a value assigned.
FX3:PDL1 LPR:PDL2
FX2:PDL1
FX1:PDL1
FX1:OFF
FX1:PDL2
FX3:OFF
FX3:PDL2
FX2:OFF
FX2:PDL2
LPR:0FF
LPR:PDL1
Tempo Exp Pedals
120 BPM
OVERDUB LO CUT
HI CUT
PLAY
LPR POST
Looper: Levels EQ
LPR PRE
Looper: Levels & EQ
In the first Setup screen you’ll see two Looper Levels to adjust in the center of the LCD.
The first is Play, which determines the volume of your Looper’s playback as balanced with
your live guitar. The second is Overdub, which determines the volume of your loop in
Overdub mode.
To clarify, if your Overdub Level is set to 90%, each time your loop begins a new overdub
its volume will be reduced by 10%, sounding quieter and quieter with each overdub pass.
The default level for Play and Overdub is 100%. Use Knobs 1 and 4 to adjust these levels.
With Knobs 2 and 5 you can adjust Looper Hi Cut and Lo Cut EQ levels. Hi Cut rolls off
the high end for loop playback (@2kHz), and Lo Cut rolls off the low end (@500Hz). If
applied, this EQ affects the sound of loop playback only, having no effect on live guitar.
Knob 3 sets the Looper to play back Pre or Post the enabled FX in your current Scene. See
Chapter 5 for more details about using the Looper.