User Manual

36
SHORTCUT: Alternatively, press PAGE , press Knob 3 (Learn) and then
either move the desired expression pedal or send the desired MIDI CC mes-
sage from your MIDI controller. HX Stomp automatically selects it.
TIP: By default, bypass toggling for the block via EXP 1 or EXP 2 is con-
guredfor"heeldown=o"behavior.Toreversebypassbehavior,press
the Upper Knob (bypass). In such case, the block will be bypassed when
movingtheexpressionpedalpasttheconguredPositionlocation.Since
itispossibletocongurethebypassofmultipleblockstobeassignedto
anexpressionpedal,youcanseteachblock'sPositionvaluedierently-
therebyallowingthepedaltoturnsomeblocksonandothersoatdierent
positions in the pedal's travel.
5. If desired, press PAGE and turn Knob 1 (MIDI In) to assign an
incoming MIDI CC message to turn the block on and o.
IncomingCCvalues0-63turntheblocko;values64-127turntheblockon.Note
that some MIDI CCs are reserved for global functions and cannot be selected -
see "MIDI CC".
Clearing Bypass Assignments
1. From the Bypass Assign screen, select the block whose bypass
assignment you want to clear and press ACTION.
2. Press Knob 1 (Clear Assignments).
Clearing All Bypass Assignments
1. From the Bypass Assign screen, press ACTION.
2. Press Knob 2 (Clear All Assignments) to clear all blocks' By-
pass assignments.
The following dialog appears:
OKCancel
Clear all assignments?
3. Press Knob 3 (OK).
Swapping Stomp Footswitches
If you want to change the location of Stomp mode footswitches (especially those with
multiple items assigned), instead of manually reassigning everything, you can quickly
swap all assignments between two stomp footswitches.
1. Touch (but don't press) any two Stomp footswitches until the
following dialog appears:
OKCancel
Swap FS1 and FS2?
2. Press Knob 3 (OK).
Tips for Creative Bypass Assignment
• Ifyoundyourselfconstantlytogglingoneswitchoandanotheron,assign
both blocks to the same footswitch, and while one is selected, press the
UpperKnob.Nowpressingthefootswitchwilltoggleoneoandtheotheron
simultaneously.
• Assign a Wah block to be engaged only when moving an expression pedal
past 1%. Set the Wait time long enough so that natural foot movements don't
turnthewahoeverytimeyoureachtheheel-downposition,butnosolong
thatit turnsonoticeablylatewhen youresttheexpressionpedalat heel-
down - See "Manual Bypass Assign".
• Dierentblockscanbeenabledorbypassedatdierentlocationsofanexpres-
sion pedal's travel. Experiment with turning on multiple overdrive blocks—one
at Position 5%, another at Position 30%, another at Position 70%, and so on.
• When using a footswitch to toggle between two Amp or Amp+Cab blocks,
theampmodelsmaysoundnotablydierentfromoneanother(justlikereal
amps!). Use an EQ block to make one Amp block sound a bit closer to the
other Amp block and assign its bypass to the same footswitch.
• Assign a delay block with very high feedback to be turned on only when reach-
ing the toe position of an expression pedal. Squeals galore.