User Manual

35
Bypass Assign
Aside from pressing the Upper Knob from Edit view, HX Stomp has a variety of ad-
ditionalmethodsforturningblocksonando:
• Pressing a Stomp mode footswitch
• Moving a connected expression pedal (sometimes called "auto-engage")
• Sending a MIDI CC message to HX Stomp's MIDI In (or via USB)
Quick Footswitch Assign
1. While in Edit view, turn the Upper Knob to select the block you
wish to assign to a footswitch.
2. While in Stomp footswitch mode, touch and hold FS1 or FS2
(or FS3 if Global Settings > Footswitches > FS3 Function is set
to "Stomp 3") until the following dialog appears:
OKCancel
Assign block to FS?
Merge
Assign
If you want to replace any other blocks that may already be assigned to the foot-
switch, turn Knob 2 (Assign) to "Replace." Otherwise, leave it set to "Merge,"
which allows for multiple blocks to be assigned to the same switch.
3. Press Knob 3 (OK).
Manual Bypass Assign
1. Press PAGE and PAGE together to open the Menu.
2. Press Knob 1 (Bypass Assign).
The Bypass Assign screen looks very similar to the Edit screen:
16B Pastor of Muppets
Harmony Delay
Bypass Assign
FS2 Latching
TypeSwitch
3. Turn the Upper Knob to select the block you want to bypass.
Input, Output and Mixer blocks cannot be assigned. Split blocks can be assigned;
when bypassed, the Split Y and Split A/B type blocks revert to an even signal split
to each path, and the Split Crossover type applies no frequency split, with the
signal fed to each path evenly.
4. Turn Knob 1 (Switch) to select the desired footswitch or ex-
pression pedal.
None
Removes the bypass assignment.
FS1-FS5
Steppingonthe Stompmodefootswitchturnstheblockon and o.
Note that FS3, FS4 or FS5 won't function unless Global Settings > Foot-
switches > FS3 [FS4, FS5] Function is set to "Stomp 3 [Stomp 4, Stomp
5]."
Selecting a footswitch displays Knob 2 (Type). Turn Knob 2 to select
"Moment[ary]" or "Latching" behavior. When set to Momentary, the
block is bypassed (or enabled, if already bypassed) for as long as you
hold the switch. When set to Latching, the block is bypassed (or en-
abled, if already bypassed) every time you press the switch.
EXP 1, EXP 2
Moving the expression pedal automatically enables (or bypasses) the
block.
Selecting EXP 1 or 2 displays Knob 2 (Position) and Knob 3 (Wait). Po-
sition determines where in the expression pedal's travel the block is
enabledorbypassed.0%isheeldown;99%istoedown.Waitdeter-
mines how long HX Stomp waits before bypassing the block; for ex-
ample,youwouldn'twantthewahtoturnoeverytimeyoutouched
the heel down position in your big funk wah solo.