User Manual

29
`
Looper
A single mono or stereo Looper block can be added.
The 1 Switch Looper only functions if it has been assigned to a footswitch in Stomp
mode. See "Bypass Assign" for information on how to assign blocks to footswitches.
You can also access Looper functions via MIDI - see "MIDI CC".
Looper Type Max. Loop Length (Full Speed)
Mono
60 seconds
Stereo
30 seconds
1. Add a 1 Switch Looper block to your preset and assign it to a
footswitch in Stomp mode.
See "Quick Footswitch Assign".
2. Press the 1 Switch Looper switch.
The LED lights red, indicating the loop is recording.
3. Press the 1 Switch Looper switch again.
The LED lights green, indicating the loop is playing back.
4. Press the 1 Switch Looper switch again.
The LED lights amber, indicating the loop is in overdub mode. Subsequent press-
es of the switch toggle between play and overdub mode.
5. While the Looper is in play or overdub mode, press and hold
the switch for 1 second.
The most recent recording is undone. Holding the switch again will redo the re-
cording.
6. Quickly double-press the 1 Switch Looper switch.
Playback/recording stops and the LED lights white, indicating a loop is in memory.
7. While Looper playback/recording is stopped, press and hold
the switch.
The recording is deleted and the LED lights dim white.
IMPORTANT! You may change presets while looping, but loop playback will
stop unless the preset you select includes the same type of looper block (mono
or stereo).
Looper Settings
Page Knob Parameter Description
1
1 Playbk
Adjustslooperplaybacklevel.Youmaynditusefulto
turn this down a bit so your live guitar can be slightly
louder.
2 Ovrdub
Relatively sets the level of your loop while overdubbing.
Forexample,ifyourOverdubLevelissetto90%,each
time your loop repeats, its volume will be reduced by
10%, sounding quieter and quieter with each overdub
pass.
3 Low Cut
Filters a portion of the loop's bass and/or treble
frequencies, which can improve the mix with your live
guitar.
2 1 High Cut
Split
A Split block appears any time a parallel path is created, but is visible only when se-
lected:
HXStomphasthreedierenttypesofSplitblocks—Y,A/B,andCrossover.
Turn the Upper Knob to select the Split block and then turn the
Lower Knob to change the Split type.
Split > Y Settings
Knob Parameter Description
1 BalnceA
Adjusts the left/right stereo balance of Path A.
2 BalnceB
Adjusts the left/right stereo balance of Path B.
TIP: Okay, this one's for the power users: If you move a Split > Y block all the
way left, set its BalnceA to "L100" and its BalnceB to "R100," you can process
the L/MONO and RIGHT inputs independently. In addition, if you route the Mixer
block to Path B (Send L/R), you can process two instruments simultaneously,
each with its own mono input, stereo processing, and stereo outputs!