User Manual

17
NOTE: Inputs, Outputs, Splits, Merges, and Loopers can also be copied and
pasted. However, if you, for example, try pasting the Looper into the Split
block's location, Knob 2 (Paste Block) will be grayed out. Furthermore, if the
destination path’s DSP cannot accommodate the copied block, the header
willbrieyread“CannotPaste—Path1[or2]DSPfull!”See"Dynamic DSP"
Clear
Block
Clear All
Blocks
Copy
Block
Paste
Block
Cannot Paste—Path 1 DSP Full!
Clearing a Block
1. From the Home > Signal View screen, select the block you
wish to clear and press ACTION.
2. Press Knob 3 (Clear Block).
Clearing All Blocks
Clearing all blocks removes all processing blocks (including the Looper) and resets
bothPath1and2toserial.ItdoesnotaectPath1AorPath2AInputandOutput
blocks,nordoesitaectthe"Command Center"
1. Press ACTION.
2. Press Knob 4 (Clear All Blocks).
The following dialog appears:
OKCancel
Clear all blocks?
3. Press Knob 6 (OK).
Saving/Naming a Preset
1. Press SAVE to open the Save Preset screen:
Cancel Delete Insert
Replace 1 FACTORY 1 > 26A M’Lady Neckbeard
Setlist
1
Destination
26A
Save Preset
Save
M ‘ L a d y N e c k b e a r d
L
N
O
P
J
K
Move the joystick left or right to move the cursor.
Turn the joystick (or move it up/down) to change the selected character.
Press Knob 2 (Delete) to delete the selected character and shift all following
characters to the left.
Press Knob 3 (Insert) to insert a space and shift all following characters to
the right.
SHORTCUT:PressthejoysticktocyclethroughA,a,0,and[SPACE].
2. Turn Knob 4 (Setlist) and Knob 5 (Destination) to choose the
Setlist and Preset location you wish to overwrite.
Any of the 1,024 presets can be overwritten.
3. Press SAVE again or Knob 6 (Save).
TIP: You may want to create a backup before overwriting the presets on your
device - it's easy to do on your Mac or PC using the free Helix editor application
from line6.com/software!