User Manual

14
2. Press the footswitch displaying the block you want to edit.
Theblock'srstpageofparametersappearatFS1—FS6.
HOLD TO EDIT
TUNER
TAP
MODE
DCBA
16B Dream Rig Duet
1
Filter Mutant Filter
Peak Gain Range Drive MixMode
1.5 Low Up 100%8.0Band Pass
Mode GainPeak Range Drive Mix
BACK
PAGE
PAGE VALUE– VALUE+ EXIT
BA C D
If the block has more than one page of parameters, press FS8 (<PAGE) or FS9
(PAGE>) until you nd the parameter.
3. Press the footswitch displaying the parameter you want to ad-
just.
Press and hold a Time or Speed switch to toggle between setting the value in ms
or Hz and note divisions (1/4-note, dotted 1/8-note, etc.).
4. Use the expression pedal to adjust the parameter.
For ne adjustment, press FS10 (VALUE–) and FS11 (VALUE+). Hold FS10
(VALUE–) or FS11 (VALUE+) for faster adjustments.
Toselectadierentblock,press FS7 (BACK).
5. When nished, press FS12 (EXIT).
If you want to save any changes made to the preset, hold FS12 (EXIT) for two
seconds.
Selecting Blocks/Adjusting Parameters
Blocks are objects that represent various elements of a preset, such as amps, cabs,
eects,splits,loopers,andeveninputsandoutputs.
1. From Stomp footswitch mode, briey touch (but don’t press)
the footswitch assigned to the desired block.
The selected block appears with a white box on the main LCD:
If multiple blocks are assigned to a footswitch, its Performance View box reads
“MULTIPLE (X).” Touch the top of the switch repeatedly until the desired block
is selected.
NOTE: Repeatedly touching a "MULTIPLE (X)" switch may jump to complete-
lydierentscreens,dependingonitsassignments.Forexample,ifaswitch
isassignedtoaneectblock,aneectparameter,and a Command Center
MIDI message, repeated touches will cycle through all three items on the
Home, Controller Assign, and Command Center screens, respectively. Basi-
cally, anything on the switch is only a touch away.
Alternatively, move the joystick to select a block.
SHORTCUT: Press to quickly select the Amp+Cab, Amp, or Preamp
block and its tonestack parameters (Gain, Bass, Mid, Treble, etc.) appear.
If a preset has more than one of these blocks, press repeatedly to cycle
through all tonestacks.
2. Turn Knobs 1-6 below the screen.
Some blocks have more than one page of parameters, in which case dots on the
right side of the inspector indicate the current page. For example, the dots below
indicate that page 1 parameters are visible (the colored dot) and a total of four
pages of parameters are available:
3. Press <PAGE/PAGE> to access more parameters (if available).