User Manual

6
1. INPUT Jack – Plug in your guitar here.
2. PRESET Encoder – Turn to select one of the 16 available presets. A
preset stores the value of each knob, as well as the FX 1, 2 & 3 model
types and their bypass states.
3. DRIVE Knob – Drive is like the volume or gain knob on other amps;
it controls how much “dirt” or “distortion” you get in your sound.
4. TONE Knob – This knob is a macro control for the overall tonal
settings for each amp, utilizing bass, mid and treble controls under-
the-hood. Turn this down for a warmer tone, or up for a brighter
sound, with a atter or "scooped" sound at 12 o'clock.
5. VOLUME Knob – Controls the volume of the preset independently
of the MASTER Volume Knob. Use this knob to match volumes
between presets.
6. REVERB Knob – Controls the mix and depth of the Reverb eect.
Turn it up or down for more or less ambience.
7. FX Knob – Controls how much of each of the three enabled on-
board eects are applied. To adjust a particular eect amount, select
and enable the desired eect using the three FX Buttons.
8. FX 1, 2 & 3 Buttons – These buttons select and control the bypass
state of the three on-board eects. The FX Knob controls how much
of the currently selected eect is applied to the sound.
There are ve dierent types of eects available, with each type
displaying a corresponding color: yellow for Dynamics/Compression,
orange for Distortion, blue for Modulation, green for Delay/Echo, and
purple for Filter/Pitch/Synth.
9. SAVE Button – Press to store the values of the knobs and state of
the FX buttons within the currently selected preset.
10. TAP/TUNER Button – Tapping this button a few times sets the
tempo of your delay and modulation eects in use.
Pressing and holding this button for 2 seconds engages the Tuner.
The Tuner mutes the guitar signal and utilizes the three FX Buttons'
lights to indicate your pitch by displaying red on the left (at), red
on the right (sharp) or green in the middle (in-tune). Press the TAP/
TUNER button once to exit the Tuner.
11. MASTER Volume Knob – You can choose the overall volume of the
amplier (or headphones, if connected), without aecting the overall
tone or saturation. Always start with the MASTER knob set to
minimum!
12. PHONES Output – Connect a pair of headphones here. When you
do so, the speaker is muted. This jack also doubles as a direct output.
Use a stereo TRS cable to connect to a mixer or recording device.
13. USB (Micro B connector) – Connect a Mac, PC, iOS device (with
Apple USB Camera Connection Kit) or Android device (with OTG
adapter), to edit tones using the Spider V Remote application, or to
playback and record audio.
Controls and Connections
SAVE
FX FX FX
1
2
3 4
5
6
7
8
9
10
11
12
13
ACOUSTIC
CLEAN
VIBE
CHIME
CRUNCH
AMBIENT
BASS
CHUNK
INSANE