User Manual

7
+
+
Powercab 112 Plus & 212 Plus - Rear Panel Controls
PUSH
PUSHPUSH
8
9
10
11
1312 15
16
18
17
19 20
14
OUTPUTS INPUTS 12
LEFT/MONORIGHT/AUXLEFT/MONORIGHT
*
Powercab 212 Plus rear panel (112 Plus features dier slightly, as noted below)
8. POWER Switch - Turns the Powercab on or o.
9. AC In - Connect the included IEC power cable here�
10. *LOW CUT Switch -
+
Powercab 112 Plus only� Toggles the
80Hz Low Cut Filter on/o, useful for removing unwanted low end
vibration (does not apply to the XLR or L6 LINK - AES/EBU
Outputs' signals)�
*
+
On Powercab 212 Plus, access the Low Cut feature within
the Global Settings�
11. GROUND GND/LIFT Switch - Controls whether the ground circuit
is lifted for the XLR Output jacks� Can be useful for identifying ground
loops, which can cause unwanted hum�
12. & 13. XLR Output Jacks - Connect to a mixer's input� The output
level is switchable between Line Level (+13dBu) or Mic Level
(~0�0dBu) - see "Global Settings" on page 17�
+
Powercab 112 Plus includes only a single XLR Output jack�
NOTE: XLR Outputs are not aected by 48V phantom power.
14. & 15. Combo Input Jacks - Connect the line level output(s) of your
amp modeler to these balanced 1/4" TRS/XLR inputs (e�g�, Line 6
Helix
®
or POD
®
devices, etc�)� A Helix device should be set to Line
Level� A POD
®
HD device should be set to +4dB� "Amp-in-a-box"
type preamp pedals may require additional boosting to achieve the
appropriate line level for these inputs (maximum +13dBu)�
16. USB-B Jack - Connect to a Mac or PC to use the Powercab Edit
software to load IRs, customize, backup & restore all presets, or
to use the Line 6 Updater software� Both are available free from
line6�com/software/�
17. & 18. MIDI IN, OUT/THRU Jacks - Connect to your MIDI gear
for sending and receiving MIDI program change and continuous
controller messages� Connect a second Powercab Plus to send
patch changes to both units�