User Manual
Table Of Contents
- POWERCAB FAMILY Pilot's Guide
- Specifications
- Overview
- Powercab 112 Plus & 212 Plus - Top Panel Controls
- Powercab 112 Plus & 212 Plus - Rear Panel Controls
- Powercab 112 - Rear Panel Controls
- Speaker Models vs Cabinet Modeling
- Powercab Speaker Models
- User Presets
- Impulse Responses
- Powercab Edit Software
- USB Audio
- Global Settings
- Setup Examples
- L6 LINK
- AES/EBU
- MIDI
22
+
+
Powercab Plus USB Processing (Instrument Level)
If for some reason your modeler is unavailable, borrowed, stolen, broken,
etc�, your Powercab Plus can still perform! Using a computer in lieu of
a dedicated hardware modeler, Powercab Plus can double as an audio
interface with DSP for speaker modeling and IR processing� This can be
used in tandem with a DAW or a plug-in, such as Line 6 Helix Native, to
process the guitar signal�
RIGHT/
AUX
USB
1. Connect the guitar directly to Powercab Plus Input 2 (Right/Aux)
2. Connect a USB cable to a computer or mobile device�
3. On Powercab Plus, navigate to Global Settings by holding the
HOME button and set Input 2 Mode to USB�
4. Optional: If you want to add speaker modeling or IRs to the output
signal, set the USB Mode to Processed�
NOTE: If you are playing backing tracks through Powercab Plus, set
the USB Mode to Normal to hear them unprocessed�
+
+
Powercab Plus Digital Stereo Setup
FXFX
PREAMP
L6 LINK or AES
L6 LINK
or AES
1. Connect a L6 LINK/AES cable from the Helix/POD HD device to
the L6 LINK Input on Powercab Plus�*
2. Connect a L6 LINK/AES cable from the rst Powercab Plus L6
LINK Output to a second Powercab Plus L6 LINK Input�
3. Optional: Connect XLR cable(s) to the output of each Powercab
Plus to send to a mixing board or recording interface� The output
signal will have a user-dened microphone model applied when
using speaker models, congurable within the preset on Powercab
Plus�
Also see "L6 LINK" on page 23�
*NOTE: A 110Ω type XLR cable should be used for all L6 LINK and
AES connections�