User Manual
Table Of Contents
- POWERCAB FAMILY Pilot's Guide
- Specifications
- Overview
- Powercab 112 Plus & 212 Plus - Top Panel Controls
- Powercab 112 Plus & 212 Plus - Rear Panel Controls
- Powercab 112 - Rear Panel Controls
- Speaker Models vs Cabinet Modeling
- Powercab Speaker Models
- User Presets
- Impulse Responses
- Powercab Edit Software
- USB Audio
- Global Settings
- Setup Examples
- L6 LINK
- AES/EBU
- MIDI
21
+
+
Powercab Plus Analog Setup
OR
1. Connect the 1/4" or XLR output(s) from the modeler/processor
to the combo input(s) on Powercab Plus�
2. Optional: Connect XLR cable(s) to the output of Powercab Plus
to a mixing board or recording interface� The output signal will have
a user-dened microphone model applied when using Speaker
models, congurable within the Powercab Plus preset.
+
+
Powercab Plus Doubling as a Floor Monitor for Vocals
L6 LINK
OUTPUT
LEFT/MONO INPUT 2
OUTPUT
RIGHT
1. Connect your modeler to Powercab 112 Plus or 212 Plus using
either analog or L6 LINK/AES cables�
2. Connect an XLR or 1/4" balanced cable from a mixer or audio
interface's Aux or Monitor Send (as would be used to route to active
monitors)�
3. On Powercab, navigate to Global Settings by holding the
HOME button and set Input 2 Mode to Monitor� This will use a
separate crossover and lters to provide at-response, full-range
audio through the Powercab built-in amplier and speaker(s) – just
like an active PA monitor�
XLR output(s) on Powercab Plus can still be used but will only output
processed signals from Input 1 or L6 LINK�